1MG26-LFW0-00C-200 - 3M Electronic Solutions Division

Interconnect Solutions

http://www.3M.com/interconnects/

3M is a trademark of 3M Company.

For technical, sales or ordering inform at io n call

800-225-5373

™

Shrunk Delta Ribbon (SDR) Cable Assembly

.80 mm High Speed Digital Data Transmission, 26 position 1MG26-LFW0-00C-XXX

Physical

Electrical

Environmental

Camera Link is a certification mark of Automated Imag ing Association.

Connector Contact Plating:

Wiping Area: 30 μ″ [ 0.76 μm ] Min Gold

Underplating: 100 μ″ [ 2.55 μm ] Nickel

Shell Options:

Color: Silver ( MDR), Black (SDR)

Material: Polyvinyl Chloride (SDR ) Me tal Plated Polyester Elastomer (MDR)

Cable:

Color: Beige

Jacket Material: Polyvinyl Chloride (PVC)

Flammability: AWM VW -1

Marking: 3M Logo

Voltage Rating: 30 V

Current Rating: 0.5 A

Insulation Resistance: 1 × 108 Ω min at 100 VDC

Withstanding Voltage: 125 VAC RMS for 1 minute

Temperature Rating: 0°C to +70°C

TS-2128-C

Sheet 1 of 3

• Supports new AIA Industrial Camera Link®

Standard for new Mini C/L camera to C/L

frame grabber applications

• 11 shielded, twisted twinax pairs with four

drain wires

• Double overall shield with inner foil and

outer braid

• Rugged ribbon contact type

• EMI shielded cable assembly

• For use as bulkhead feed through or

extension cable

• See regulatory information appendix (RIA)

for chemical compliance information

Date Modified: December 10, 2007

UL File No.: E86982

Interconnect Solutions

http://www.3M.com/interconnects/

3M is a trademark of 3M Company.

For technical, sales or ordering information call

800-225-5373

™

Shrunk Delta Ribbon (SDR) Cable Assembly

.80 mm High Speed Digital Data Transmission, 26 position 1MG26-LFW0-00C-XXX

TS-2128-C

Sheet 2 of 3

Figure 2 - SDR Plug Pinout

Figure 1

MDR Receptacle To SDR Plug Bulkhead Cable Assembly

Figure 3

MDR Receptacle Pinout

41.0

1.6

LENGTH

Cable

(S ee pi nout for cabl e construction)

2X M2.0 Thu mbs cr ew

Hi gh Densit y SD R

Male Plug

26 Position

Hi gh Dens it y MD R

Female Receptacle

26 Position

(See ordering information)

32.0

1.26

12345678910111213

14 15 16 17 18 19 20 21 22 23 24 25 26

9.0

0.35 12.0

0.47

24.4

0.96

12345678910111213

14151617181920212223242526

12.5

0.49

40.6

1.6

[Inch]

Tolerance Unless Noted

[ ] Dimensions for

Reference only

± .10

± .1

0.00

0.0

Interconnect Solutions

http://www.3M.com/interconnects/

3M is a trademark of 3M Company.

For technical, sales or ordering information call

800-225-5373

Cable

25 CC4- Z3+ Z3+ CC4- 25

12 CC4+ Z3- Z3- CC4+ 12

24 CC3+ Zclk+ Zclk+ CC3+ 24

11 CC3- Zclk- Zclk- CC3- 11

23 CC2- Z2+ Z2+ CC2- 23

10 CC2+ Z2- Z2- CC2+ 10

22 CC1+ Z1+ Z1+ CC1+ 22

9 CC1- Z1- Z1- CC1- 9

21 Ser TFG+ ZO+ ZO+ Se r TFG+ 2 1

8 Ser TFG- ZO- ZO- Se r TFG- 8

20 S e r TC- Terminated Termi n ated S er TC- 20

7 S er TC+ 100 ohm 100 ohm S er TC+ 7

19 X3+ Y3+ Y3+ X3+ 19

6X3- Y3- Y3- X3- 6

18 XC+ Yclk+ Yclk+ XC+ 18

5XC- Yclk- Yclk- XC- 5

17 X2+ Y2+ Y2+ X2+ 17

4X2- Y2- Y2- X2- 4

16 X1+ Y1+ Y1+ X1+ 16

3X1- Y1- Y1- X1- 3

15 XO+ YO+ YO+ XO+ 15

2XO- YO- YO- XO- 2

1INNER

SHIELD INNER

SHIELD 1

14 INNER

SHIELD INNER

SHIELD 14

13 INNER

SHIELD INNER

SHIELD 13

26 INNER

SHIELD INNER

SHIELD 26

Shell Shell

TWINAX 10

TWINAX 11

DRA IN WIRE

BRAID SHIELD

CN-2

Conn.

Pos.

TWINAX 5

TWINAX 6

TWINAX 7

TWINAX 1

TWINAX 2

TWINAX 3

TWINAX 4

CN-1

Conn.

Pos.

TWINAX 9

B ase Configuration

Ful l / M edi um configuratio n

TWINAX 8

™

Shrunk Delta Ribbon (SDR) Cable Assembly

.80 mm High Speed Digital Data Transmission, 26 position 1MG26-LFW0-00C-XXX

1MG26-LFW0-00C-XXX

Notes:

1. For a cable length of less than 2m, the length tolerance is +50mm / -0mm

2. For a cable length of 2m or more, the length tolerance is +3% / -0% of cable length

Ordering Information

Length:

100 = 1m

200 = 2m

500 = 5m

A00 = 10m

Reference notes 1 & 2 fo r cabl e length tolerance

TS-2128-C

Sheet 3 of 3

Cable Assembly Wiring Diagram

Table 1

(RIA E1 & C1 apply)

Regulatory Information Appendix

3M Electronic Solutions Division/Interconnect

EUROPE

Appendix E1: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product is RoHS Compliant 2005/95/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in excess of

the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/EC, unless

the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this information

represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E2: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product contains lead in the compliant pin area in excess of the maximum concentration value allowed but is

compliant by exemption under EU Commission Decision 2005/747/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in excess of

the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/EC, unless

the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this information

represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E3: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment as

amended by Commission Decision 2005/618/EC.

This product contains lead in the solder tail area in excess of the maximum concentration value allowed.

Unless otherwise stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon information

provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E4: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product contains decaBDE in the insulating material in excess of the maximum concentration value allowed but is

compliant by exemption under EU Commission Decision 2005/717/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in excess of

the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/EC, unless

the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this information

represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

RIA-2217B-c

Appendix E5: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product contains lead in excess of the maximum concentration value allowed but is compliant by exemption under

Item 6 of the Annex to the Directive.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in excess of

the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/EC, unless

the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this information

represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

CHINA

Appendix C1: China RoHS

Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits for

Certain Hazardous Substances in Electronic Information Products.

This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006, means

that the product or part does not contain any of the following substances in excess of the following maximum concentration

values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls

or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless otherwise stated by 3M in writing, this

information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and

Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix C2: China RoHS

Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits for

Certain Hazardous Substances in Electronic Information Products.

This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006, means that

the product or part does contain a substance, as detailed in the chart below, in excess of the following maximum concentration

values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls

or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless otherwise stated by 3M in writing, this

information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

The numerical reference in the symbol above should not be construed as a representation regarding the product’s life or an

extension of a product warranty. The product warranty is stated below. In the event any product is proven not to conform with

3M’s Regulatory Information Appendix, then 3M’s entire liability and Buyer’s exclusive remedy will be in accordance with the

product Warranty stated below.

RIA-2217B-c

Important Notice

All statements, technical information, and recommendations related to 3M’s products are based on information believed to be reliable, but the accuracy or completeness

is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability associated

with such use. Any statements related to the product which are not contained in 3M’s current publications, or any contrary statements contained on your purchase order

shall have no force or effect unless expressly agreed upon, in writing, by an authorized ofﬁcer of 3M.

Warranty; Limited Remedy; Limited Liability.

This product will be free from defects in material and manufacture for a period of one (1) year from the time of purchase. 3M MAKES NO OTHER WARRANTIES

INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the

warranty period stated above, your exclusive remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except

where prohibited by law, 3M will not be liable for any indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of

the legal theory asserted.

Please recycle. Printed in USA.

RIA-2217B-c

3M Electronics

Interconnect Products

6801 River Place Blvd.

Austin, TX 78726-9000

U.S.A.

1-800-225-5373

www.3m.com/interconnects 3M is a trademark of 3M Company.

Appendix C3: China RoHS