ROBOT-M24LR16E-A Evaluation board for the M24LR16E-R dual interface EEPROM Data brief Features 20 mm x 40 mm 13.56 MHz inductive antenna etched on PCB M24LR16E-R dual interface EEPROM IC connector Energy harvesting output (VOUT) with a capacitance filtering circuit RF WIP/BUSY output with 20 k pull-up resistor, to indicate that an RF operation is ongoing Description The ROBOT-M24LR16E-A is a ready-to-use PCB that features an M24LR16-R dual interface EEPROM IC connected to an IC bus and a 20 mm x 40 mm 13.56 MHz etched RF antenna. It also features two LEDs, powered by the M24LR16E-R VOUT pin and an output connector. The ROBOT-M24LR16E-A has three functions: Switch in the "LED" position: the robot demonstrates energy harvesting by powering the LED when a sufficient magnetic field is captured. Switch in the "VOUT" position: the energy captured from the electromagnetic field is used to power an external application through the VOUT pin. RF WIP/BUSY function: for the RF WIP/BUSY pin of M24LR16E-R, please refer to the M24LR16E-R datasheet for further details. To demonstrate the energy harvesting function, the ROBOT-M24LR16E-A can be used in conjunction with ST DEMO-CR95HF-A demonstration board. September 2011 Doc ID 022238 Rev 1 For further information contact your local STMicroelectronics sales office. 1/5 www.st.com 5 ROBOT-M24LR16E-A Figure 1. Functional block diagram &ILTERING CIRCUIT ,%$S 3WITCH 6/54 6/54 6## 6## K7 !# 2& 7)0"539 2& 7)0"539 -,2% ! !# 3#, )# BUS 3$! '.$ -36 2/5 Doc ID 022238 Rev 1 ROBOT-M24LR16E-A 1 Associated firmware and PC software Associated firmware and PC software The ROBOT-M24LR16E-A is supported by a PC software, the Dual Interface EEPROM tool software, that allows to configure and control the energy harvesting. This software is available from http://www.st.com. Refer to application note AN3954 "Developing your own Visual Basic or C/C++ application on a DEMO-CR95HF-A demonstration board", for how to adapt the PC software for your application. 2 Ordering information Table 1. Device summary Order code ROBOT-M24LR16E-A Reference ROBOT-M24LR16E-A evaluation board Doc ID 022238 Rev 1 3/5 Revision history 3 ROBOT-M24LR16E-A Revision history Table 2. 4/5 Document revision history Date Revision 27-Sep-2011 1 Changes Initial release. Doc ID 022238 Rev 1 ROBOT-M24LR16E-A Please Read Carefully: Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries ("ST") reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST's terms and conditions of sale. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein. UNLESS OTHERWISE SET FORTH IN ST'S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. UNLESS EXPRESSLY APPROVED IN WRITING BY TWO AUTHORIZED ST REPRESENTATIVES, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER'S OWN RISK. Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST. ST and the ST logo are trademarks or registered trademarks of ST in various countries. Information in this document supersedes and replaces all information previously supplied. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners. (c) 2011 STMicroelectronics - All rights reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com Doc ID 022238 Rev 1 5/5