P Cut the Cable TM Bluetooth V2.0 Embedded PAN1555-EMB-2.0 OUTLINES - ENW89815A3KF M ODULES Panasonic Electronic Devices Europe GmbH IRELESS W Now you can integrate Bluetooth very easy in your final product, without qualification - with the PAN1555. This solution follows the national and international regulations, e.g. CE (Radio, EMC, Safety), FCC and IC. The PAN1555 is manufactured in a 13.50 x 22.75 x 2.85 mm SMD package with an integrated ceramic antenna or plug and will be qualified as a Bluetooth 2.0 product. Re-qualification of your product is usually not required. This is why the PAN1555 is particularly suited for units produced in smaller or medium quantities. This module is a one to one replacement for the well known PAN1550. Any customizations for the software can be handled with our recommended partners. FEATURES General - Complete Bluetooth 2.0 + EDR solution - Full product qualification (Bluetooth, CE, FCC, IC) - Profiles: GAP, SDAP, SPP, HID and HDP available, other could be supported on request. - CSR BlueCore6-ROM inside - Cortex-M3 ST32F103 core for embedded profiles or application software - Temperature Range from -40C to +85C - Supply Voltage Range from 2.7V to 3.6V, typ. 3.3V - Fast Connection Setup - Support for 802.11 Coexistence Interfaces - UART (programmable baud rate), USB, IC, SPI and ADC - 18 GPIOs for individual usage for your embedded software - All bluetooth data rate up to 2178kbps asymmetric - PCM Interface Master / Slave supporting 13 or 16 bit linear, 8 bit -law or A-law Codecs and CVSD transcoders on up to 3 SCO channels. Bluetooth - High Sensitivity Design (typ. -86 dBm) - Full 8- to 128-bit encryption - Power control and RSSI, Hold-, Park- and Sniffmode - Support for very low power modes - sleep and deep sleep Design and Specifications are subject to change without notice. Ask the factory for technical specifications before purchase and/or use. If there is any doubt regarding the safety of this product, kindly inform us immediately for technical consultation. PAN1555 Rev. B1 www.pedeu.panasonic.de wireless@eu.panasonic.com Hardware Status: Mass Production P CONTACT Dipl.-Ing. Ingo Wagner Product Engineer Module Business Panasonic Electronic Devices Europe GmbH Zeppelinstrasse 19 21337 Luneburg, Germany Tel. (49)-4131-899-173 Fax (49)-4131-899-177 Ingo.Wagner@eu.panasonic.com APPLICATIONS All Embedded Wireless Applications - Printer Adapters - Printers - Access Points - Wireless Sensors - Industrial Applications - Cable Replacement Personal Digital Assistants (PDAs) Personal Navigation Devices Medical Applications BLOCK-DIAGRAM TECHNICAL CHARACTERISTICS Parameter -3 Receiver Sensitivity (BER=10 ) Output Power Value Condition / Note -86 dBm typ. ideal wanted signal +4 dBm typ. Power Supply 2,7 - 3,6 V Single operation voltage Ultra Low Power Mode <100 A T = 25C ACL (connected DH5) 50.5mA to 49.5mA max. power to min. power (1) ACL (connected DH1) 48.0mA to 46.0mA max. power to min. power (1) Operating Temperature Range -40C to +85C Storage until +125C (1) Figure indicates to the shortest poll period and to the slave mode www.pedeu.panasonic.de wireless@eu.panasonic.com Hardware Status: Mass Production