POWER
DS460S
460 Watts
Total Output Power: 460 Watts
+12 Vdc Stand-by Output
Wide Range Input Voltage:
90 - 264 Vac
SPECIAL FEATURES
Active power factor correction
EN61000-3-2 harmonic compliance
Active AC inrush control
1U X 2U form factor
+12 Vdc output
+12 Vdc stand-by
Hot plug operation
N + 1 redundant
Active current sharing
Built-in cooling fan
I2C communication interface bus
PMBus compliant
EEPROM for FRU data
Two years warranty
SAFETY
UL/cUL 60950 (UL Recognized)
NEMKO 60950
Cb Certicate and report
CE Mark (LVD)
Electrical Specications
Input
Input ra nge: 90 - 264 Vac
Frequency: 47 - 63 Hz, single phase AC
Inrush current: 30 Apk maximum inrush current
Efficiency: 92% typical at high line 50% load
Conducted EMI: FCC Subpart J EN55022 Class A
Radiated EMI: FCC Subpart J EN55022 Class A
Power factor: 0.99 typical
Leakage current: 1.0 mA @ 240 Vac
Hold up time: 10 ms minimum
Output
Main DC voltage: +12.3 V @ 36.0 A
Stand-By: +12 V @ 2.3 A
Adjustment range: Factory Set
Regulation: 11.85 - 12.45 Vdc
11.40 - 12.6 Vdc
Overcurrent: +12 Vdc; latches off if overcurrent lasts over 1 second,
Trip point 120% - 150% of rated current.
Overvoltage: +12 Vdc; 13.6 - 15.0 Vdc
+12 Vsb; 13.6 - 15.0 Vdc
Turn-on delay: 1 - 1.5 seconds
Main output rise time: 10 - 30 mS, monotonic rise
Data Sheet
DS460S Data Sheet
Logic Control
PS_PRESENT (S4):
Used to sense the number of power supplies in the system (operational or not) and provide hot plug insertion and
removal functionality by controlling main outputs during hot plug insertion and removal by employing following
circuitry. When the unit is removed from the system the fast shut down signal quickly turns OFF main outputs and
discharges output capacitors. This signal is the shortest gold finger pin on the signal connector to allow for last
make, first break configuration.
PSOK (S6): Combined indicator of AC input and main 12 V DC output. This is a three level signal to indicate different stages
as follows.
AC not OK and DC not OK – Signal status shall be LOW (< 0.6 V)
AC OK and DC not OK – Signal status shall be LOW (< 0.6 V)
AC OK and DC OK – Signal status shall be HIGH (> 3.0 V)
AC not OK and DC OK – Signal status shall be Middle Level (Between 2 V and 2.5 V)
DC OK threshold is defined as when the 12 V output is greater than 11.5 V.
DC not OK threshold is defined as when the 12 V output is less than 11.4 V & greater than 11.3 V.
I-Mon (S7): Provides both the load sharing function (as a feedback for output regulation droop function) and 12 V output
current information.
PS INTERRUPT (S4): The signal behavior in response to certain operating condition changes in the power supply as defined in the
Firmware Specification section. This signal shall be pulled up to maximum 5 V logic level external to the PS.
PS ON (S8):
Required to remotely turn on/off the power supply. PSON# is an active low signal that turns on the main 12 V DC
output. When this signal is not pulled low by the system, or left open, the 12 V output is turned off. This signal is
pulled to a standby voltage by a pull-up resistor internal to the power supply. Refer to On/Off Timing for timing dia-
gram in TRN. When in off or standby condition, the main 12 V DC output will be less than 50 mV with respect to
output return.
Environmental Specications
Operating temperature: -10 °C to 50 °C
Storage temperature: -40 °C to +85 °C
Altitude, operating: 10,000 ft.
Electromagnetic susceptibility/Input transients: -EN61000-3-2
-EN61000-4-2, 4.3, 4-4, -4-5, 4-6, 4-11
RoHS & lead-free compliant
No tantalum caps.
Humidity:
5 to 90% RH, non-condensing
Shock and vibration specificatons: Complies with Astec Std. Specifications
MTBF (Demonstrated):
500K Hrs at full load, 50 °C
Ordering Information
Model Number Nominal Output
Voltage Set Point
Set Point
Tolerance
Total
Regulation
Minimum
Current
Maximum
Current
Output Ripple
P/P Over Current Stand-by Air Flow
DS460S-3-002 12.3 Vdc ± 0.2% +5% 1 A 36.0 A 120 mV 45.9 A - 57.5 A* 12.0 V @ 2.3 A STD
DS460S-3-003 12.3 Vdc ± 0.2% +5% 1 A 36.0 A 120 mV 45.9 A - 57.5 A* 12.0 V @ 2.3 A REV
DS460S-3-004
(5,000 m) 12.3 Vdc ± 0.2% ± 5.0% 1.0 A 36.0 A 120 mV 45.9 A - 57.5 A* 12.0 V @ 2.3 A STD
DS460S-3-005
(5,000 m) 12.3 Vdc ± 0.2% ± 5.0% 1.0 A 36.0 A 120 mV 45.9 A - 57.5 A* 12.0 V @ 2.3 A REV
*Overcurrent latches off if overcurrent lasts over 1 second, otherwise it is auto recovery.
DS460S Data Sheet
Mechanical Drawings
LED GREEN
EMI GASKET (8X)
3.5
7.6
0.8 (2X)
4.2
198.1 ± 0.6
187.8
70.86
43.2
SanAce (40 x 40 x 28 mm FAN)
Model No. 9GA0412P3J01
196.9 ± 0.65
39.9± 0.5
11.12
9.5 ± 0.6
PROGRAMMING WINDOWS
(COVERLABEL REMOVED)
136.9 (2X)
0.8 HEMMING
40.5 REF
0.7
RAMP TO FAN
TOP OF FAN TO
CHASSIS BOTTOM
9.9 8
25 (2X)
136.9 (6X)
86.4 ± 0.55
7.75 ± 0.65
LATCH(BLACK)
3.2
HANDLE
MODEL
(TEXT AS ORIENTED)
LABEL LOCATION
243.2
43.2
Weight: 1.88 lbs
DS460S Data Sheet
Connector Denitions
AC Input Connector
Pin 1 Line
Pin 2 Neutral
Pin 3 Eath Ground
Output Connector - Power Blades
PB1 Vo
PB2 Vo
PB3 Vo
PB4 RTN
PB5 RTN
PB6 RTN
PB7 RTN
PB8 RTN
PB9 Vo
PB10 Vo
L2
L1
Earth Ground
Power Supply Output Card Edge (Top Side)
PB5
S1S8
PB4 PB3 PB2 PB1
Power Supply Output Card Edge (Bottom Side)
PB6 PB7 PB8 PB9 PB10
S9 S16
Output Connector - Signal Blades
S1 VSB
S2 VSB
S3 Reserved
S4 PS INTERRUPT
S5 PS PRESENT
S6 PSOK
S7 I-MON
S8 PSON#
S9 SCL*
S10 SDA
S11 GND
S12 ADD0
S13 ADD1
S14 ADD2
S15 RTN
S16 RTN
*Supports I2C standard mode (100 kHz) only
DS460S Data Sheet
WORLDWIDE OFFICES
Americas
2900 S.Diablo Way
Tempe, AZ 85282
USA
+1 888 412 7832
Europe (UK)
Waterfront Business Park
Merry Hill, Dudley
West Midlands, DY5 1LX
United Kingdom
+44 (0) 1384 842 211
Asia (HK)
14/F, Lu Plaza
2 Wing Yip Street
Kwun Tong, Kowloon
Hong Kong
+852 2176 3333
For more information: www.artesyn.com/power
For support: productsupport.ep@artesyn.com
While every precaution has been taken to ensure accuracy and completeness in this literature, Artesyn
Embedded Technologies assumes no responsibility, and disclaims all liability for damages resulting from use of
this information or for any errors or omissions. Artesyn Embedded Technologies, Artesyn and the Artesyn
Embedded Technologies logo are trademarks and service marks of Artesyn Embedded Technologies, Inc. All other
names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners.
© 2014 Artesyn Embedded Technologies, Inc.
www.artesyn.com
DS460S-DS Rev. 08.13.14
Power/Signal Mating Connectors and Pin Types
Reference On Power Supply Mating Connector or Equivalent
AC Input Connector IEC320-C13 IEC320-C14
Output Connector PCB card edge (0.062”) Molex 459840007 (top mount)
Molex 459841122 (bottom mount)
Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
Artesyn Embedded Technologies:
DS460S-3-005 DS460S-3-004 DS460S-3-003 DS460S-3-002