Overview
Zilog’s F6482 Series MCUs, members of the Z8 Encore! XP® family, are based on Zilog’s advanced 8-bit eZ8 CPU
core. These microcontrollers are optimized for low-power, sensing, and wireless applications, and support 1.8 V
to 3.6 V low-voltage operation with extremely low Active, Halt, and Stop Mode currents, plus they offer an
assortment of speed and low-power options. In addition, the feature-rich analog and digital peripherals and serial
I/O of the F6482 Series makes them suitable for a variety of applications, including safety and security, utility
metering, digital power supervisory, hand-held electronic devices, and general motor control.
The F6482 Series features 26 to 67 port pins (Ports A–J) for general-purpose input/output (GPIO). The number of
GPIO pins available is a function of package. Each pin is individually programmable.
Features
24MHz eZ8 CPU core
16KB, 32KB, 60KB or 64KB Flash memory with in-circuit programming capability
2KB or 3.75KB internal RAM
Up to 128 bytes Non-Volatile Data Storage (NVDS)
12-bit (or 14-bit 2-pass) Analog-to-Digital Converter
o Up to 12 external channels plus dedicated inputs for Op Amps (2)
o Temperature Sensor, AVDD/2, and Bandgap
o Internal or external voltage reference and single-ended or differential inputs
12-bit Digital-to-Analog Converter (DAC)
Integrated LCD driver with blinking and contrast control for up to 96 segments (4 common by 24
segment lines)
128-bit Advanced Encryption Standard (AES) encryption/decryption hardware accelerator according to
FIPS PUB 197
Real-Time Clock (RTC) supporting both Counter and Clock modes
On-Chip Temperature Sensor
Two on-chip low power analog comparators
Two on-chip, low-power operational amplifiers
8-Channel Event System provides communication between peripherals for autonomous triggering
Full-Speed Universal Serial Bus (USB 2.0) device supporting eight endpoints with integrated USB-PHY
Two full-duplex UARTs with Local Interconnect Network (LIN), Digital Addressable Lighting Interface
(DALI) and Digital Multiplex (DMX) protocol modes. Support for 9-bit (Multi-Processor) and RS-485
(Driver Enable)
Two Enhanced Serial Peripheral Interface (SPI) controllers
I2C controller which supports Master/Slave modes
Four-channel DMA controller with direct or linked-list operation
Three enhanced 16-bit timers with Capture, Compare, and PWM capability
Two additional basic 16-bit timers with interrupt (shared as UART Baud Rate Generator)
16-bit Multi-Channel Timer which supports four Capture/Compare/PWM modules