CHEMTRONICS(R) TDS # 1050 Technical Data Sheet Freez-It(R) PRODUCT DESCRIPTION Freez-It(R) is engineered for locating thermal intermittent electrical components and cooling printed circuit boards. This circuit refrigerant system is nonflammable, residue-free and provides fast cooling action. Nonflammable High heat transfer Low static generation Non-corrosive Lowers temperature to -60F (51C) Ultra pure, filtered to <0.2 microns Leaves no residue Nonabrasive on most surfaces Contains no CFCs or HCFCs TYPICAL PRODUCT DATA AND PHYSICAL PROPERTIES Boiling Point -15.7F Vapor Density (air=1) @ 77F Solubility in Water @ 77F /1 atm Specific Gravity (water = 1 @77F) Evaporation Rate (butyl acetate=1) Appearance Odor TYPICAL APPLICATIONS Freez-It(R) can be used to: Cool Equipment for Testing Dissipate Heat While Soldering or Desoldering Isolate Thermal Intermittent Components Test Circuit Traces for Continuity Test Printed Circuit Boards for Stress Fractures Track Intermittent Failures and Shorts 3.18 0.10% by weight 1.21 >1 Clear, Colorless Liquified Gas Slight Ethereal Surface Tension (dynes/cm @ 77F) 7.8 Flash Point (TCC) None Shelflife 5 years RoHS/WEEE Status COMPATIBILITY Freez-It(R) is generally compatible with most materials used in printed circuit board fabrication, including sensitive plastics and compounds. With any circuit refrigerant, compatibility must be determined on a non-critical area prior to use. Compatibility Fair Good Good Good Poor Good Good Poor Good Good Fair Good Poor TECHNICAL & APPLICATION ASSISTANCE Chemtronics(R) provides a technical hotline to answer your technical and application related questions. The toll free number is: 1-800-TECH-401. Competitive Assessment of Freez-It(R) CFC, HCFC, CL. SOLV., VOC, and HFC numbers shown are the content by weight. Ozone depletion potential (ODP) is determined in accordance with the Montreal Protocol and U.S. Clean Air Act of 1990. The ODP of this product is 0.0. It is the sum of the ODP of the substances that may contribute to the depletion of stratospheric ozone, based upon the weight of each substance in the product's formulation. Material Buna-N Graphite HDPE LDPE LexanTM Neoprene Cross-Linked PE Polyacrylate Polystyrene PVC Silicone Rubber TeflonTM VitonTM ENVIRONMENTAL IMPACT DATA ENVIRONMENTAL IMPACT DATA CFC HCFC CL Solv. Chemtronics Freez-It 33% Less Static Competitor's Freeze Spray 0 20 40 60 80 100 % Static Generation 120 USAGE INSTRUCTIONS For industrial use only. Read MSDS carefully prior to use. No special surface preparation is required prior to using Freez-It(R). Direct spray onto the area to instantly cool components, circuit boards or adhesives. For optimum performance and pin point control, use Freez-It(R) with the attached extension tube. AVAILABILITY ES1050 10 oz. Aerosol ES1550 15 oz. Aerosol 0.0% 0.0% 0.0% VOC HFC ODP 0.0% 100.0% 0.0 NOTE: This information is believed to be accurate. It is intended for professional end users having the skills to evaluate and use the data properly. CHEMTRONICS(R) does not guarantee the accuracy of the data and assumes no liability in connection with damages incurred while using it. MANUFACTURED BY: ITW CHEMTRONICS 8125 COBB CENTER DRIVE KENNESAW, GA 30152 1-770-424-4888 DISTRIBUTED BY: REV. E (06/06)