164 AVG Semiconductors Technical Data DV74HCT164 Available O2, 1995 8-Bit Serial-Input/ Parallel-Output Shift Register This device is an 8-bit, serial-input to parallel-output shift register. Two serial data inputs are provided $o that one input may be used as a data enable. Data is entered on each rising edge of the clock. The active-low asynchronous Reset over- rides the Clock and Serial Data inputs. Output Drive Capability: 10 LSTTL Loads Outputs Directly Interface to CMOS, NMOS, and TTL Operating Voltage Range: 2 to 6 V for HC devices Low Input Current: 1 WA DC, AC parameters guaranteed from -55C to 125C + * g DV74HC164 DV74HCT164 N Suffix Plastic DIP AVG-001 Case D Suffix Plastic SOP AVG-002 Case sas {01 >) Lag) TRUTH TABLE wats | 02] he, fe i aw so, PARAL U Lt | I, Pe. reo . iS obee 0 a com 18. 9, Qp-O = Data shifted from the previous a _A Stage on rising edge at the clock input. y H = High Logic Level eser 2__ L = Low Logic Level PM 1d = hy PIN ASSIGNMENT T = Rising Edge of Clock m7 Ge a X% = Don't Care ofie 141) %ce o2[] 2 15 [) Q7 % 03 12 [) % 0; Lj 4 11 [] Os O5 10 Q, Qs [6 9 [) RESET oxo [7 8 () CLOCK ABSOLUTE MAXIMUM RATINGS = Maximum ratings are those values beyond which damage to the device may occur. Symbol Parameter Value Unit Vec__| OC Supply Voltage (Referenced to GND) a -0.5 to +7.0 Vv Vin | OC Input Voktage (Referenced to GND) =1.5 to Vee +1.5 V Vout | DC Output Voltage (Referenced to GND) | __=0.S to Vee +0.5 V lin DC Input Current, per Pin +20 | mA lour | OC Output Current, per Pin +25 mA, lec DC Supply Current, Vec and GND Pins +50 mA Po Power Dissipation in Still Air, Plastic DIP 750 mW SOP Package 500 Tsta__| Storage Temperature Range -65 to +150 " Ti. _| Lead Temperaturo, 1mm from Case for 10 Seconds 260 "| DV74HC164, DV74HCTIES 5-104 1-800-AVSEMIGUARANTEED OPERATING CONDITIONS Max HC - 164 DC ELECTRICAL CHARACTERISTICS Symbol Parameter Min | Vcc __| DC Supply Voltage, HC (HCT), Referenced to GND 2.0 (4.5) 6.0(5.5) Vin, Vout | DC Input Voltage, Output Voltage, Referenced to GND 0 Vee | TA Ambient Temperature 55 +125 | te, tr Input Rise and Fall Time: HC: Vec=2.0V 0 1000 HCT: Vec=5.5V/ HC: Vec=4.5V 0 S00 HC: Vec=6.0V 0 Unit V v C ns Symbol Parameter Conditions Vec Guaranteed Limits / Unit | Vv 25C | <85C | <125C to | -5C Vie Minimum High-Level Vout =0.1 V, llourl<20pA 2.0 1.5 1.5 1.5 V Input Voltage or Vour = Vec-0.1V 4.5 3.15 3.15 3.15 6.0 42 4.2 4.2 Vit Maximum Low-Level Vour =0.1 V, llouTls20nA 2.0 0.3 0.3 0.3 V Input Voltage or Vout = Vcec-0.1V 4.5 0.9 0.9 0.9 6.0 1.2 1.2 1.2 Vor | Minimum High-Level Vin = Vin or Vit 2.0 1.9 1.9 1.9 V Output Voltage Nourls 20 pA 4.5 4.4 4.4 4.4 6.0 5.9 5.9 5.9 Vin = Vin or Vit, lourle 4.0mA 4.5 3.98 3.84 3.7 lloutl< 5.2 MA 6.0 | 548 | 534 | 52 ; VoL Maximum Low Level Vin = Vin or Vit 2.0 0.1 0.1 0.1 V Output Voltage lloutls 20 pA 4.5 0.1 0.1 0.1 6.0 0.1 0.1 0.1 Vin = Viwor Vir, lhourl< 4.0mA 4.5 0.26 0.33 0.40 V llourl< 5.2 mA 6.0 0.26 0.33 0.40 : lin Maximum Input Vin = Voc or GND 6.0 +01 +1. | +1.0 pA Leakage Current lec Maximum Quiescent Vin = Vcc or GND 6.0 8.0 60 160 LA Supply Current (Per lour= O pA Package) AC ELECTRICAL CHARACTERISTICS over full operating conditions (C.=50pF, Input tret-=6ns) Symbol Parameter Vec Guaran Lim Unit v 25c | <85C | <125C to 55C - imax | Maximum Clock Frequency (50% Duty Cycle) 2.0 6.0 4.8 4.0. | MHz 45 30 24 20 6.0 35 28 24 tPLH, Maximum Propagation Delay Time, 2.0 175 220 265 ns tPHL Clock to O 4.5 35 44 53 6.0 30 37 45 {PHL Maximum Propagation Delay Time, 2.0 205 255 310 ns Reset to O 45 41 51 62 6.0 35 43 ss | tru, | Maximum Output Transition Time 2.0 75 95 110 ns tra. | Any Output 4.5 15 19 22 6.0 13 16 19 Cin Maximum Input Capacitance 10 10 10 pF 1-800-AVSEMI 5-10 DV74HC164, DV74HCTIE4 VOL164 Ceo | Power Dissipation Capacitance (Per Flip-Flop) Typical @ 25C, Voc = 5 V Used to determine the no-load dynamic power consumption 140 pF | Po = Crp Vec*t + lec Voc TIMING REQUIREMENTS (input t=tj=6.0ns) 7 Symbol Parameter Vee Guaranteed Limit Unit Vs} 25C to} <85C | <125C 55C tow Minimum Setup Time, 2.0 50 65 75 ns D1 or D2 to Clock 45 10 13 18 | _ 6.0 9 11 13 th Minimum held time, 2.0 5 5 5 ns Glock to D1 orb? 4.5 5 5 5 = 6.0 5 5 5 tree: Minimum Recovery Time, 2.0 5 5 5 ns Reset Inactive to Clock 4.5 5 5 5 6.0 5 5 5 bw Minimum Pulse Width, 2.0 80 100 120 ns Clock or Reset 45 16 20 24 a 6.0 14 17 20 HCT- 164 DC ELECTRICAL CHARACTERISTICS Symbol Parameter Conditions Vec Guaranteed Limits Unit Vv 25C to <65C | 125C 55C Min | Max | Min | Max! Min | Max Via | Minimum High-Level Vout = 0.1 V or Vec-0.1 V 4.5 | 2.00 2.00 2.00 Vv Input Voltage llourls 20 wA 5.5 | 2.00 2.00 2.00 Va | Maximum Low-Level | Vout =0.1 V or Vec-0.1 V 4.5 0.80 0.80 0.80) V Input Voltage lourl< 20 A 5.5 0.80 0.80 0.80 Vou | Minimum High-Level | Vin = Vicor VIH 4.5 | 4.40 4.40 4.40 Vv Output Voltage lloutis 20 wA 5.5 | 5.40 5.40 5.40 7 Vin =Vir. or Vig lloutis4.0 mA 4.5 | 3.98 3.84 3.70 Vv Vow Mavimum Low Level Vin = Vewor Vir 4.5 0.1 0.1 0.1 V Output Voltage llourls 20 pA 5.5 0.1 0.1 0.1 | Vin=Vinor Vi loutis 4.0mA | 4.5 0.26 0.33 0.40| V lin Maximum Input Vin = Vec or GND 5.5 +0.1 + 1.0 +1.0 _| Leakage Current HA hoe Maximum Quiescent Vin = Vee or GND 5.5 4.0 40 80 | uA Supply Current llout! = 0 1A Alce | Additional Quiescent | Vin=2.4V, Any One Input =-55C 25C to 125C Supply Current Vin=Vec or GND, Other Inputs 6.5 29 24 mA lour=0 pA AC ELECTRICAL CHARACTERISTICS over full operating conditions (CL=50pF, Input ty=t=6ns) Symbol Parameter Vec |___ Guaranteed Limit____ Unit v 25C | <85C | <125C to 55C fmax Maximum Clock Frequency (50% Cycle) 30 24 20 MHz tPLH, Maximum Pro tion Delay Time, 35 44 53 ne (PHL Glock to or 5.0 teu, | Maximum Propagation Delay Time, +10% 38 47 57 ns teu. | Set or Reset to QO orG thus, | Maximum Output Transition Time 15 19 22 ns tTHIL Any Output Cin Maximum Input Capacitance = 10 10 10 pF DV74HC 164, DV74HCT164 5-106 1-800-AVSEMICpp Power Dissipation Capacitance (Per Inverter) Typical @ 25C, Voc = 5 V ; Unit Used to determine the no-load dynamic power consumption, 15 pF Po = Cpp Vee" + lec Vee TIMING REQUIREMENTS (input t=tj=6.0ns) Symbol Parameter Vee Guaranteed Limit Unit Vo | 25C to! <85C | <125C 55C tsu Minimum Setup Time, Di or D2 to Clock 5.0 10 13 15 | ons th Minimum hold time, Clock to D1 orD2 5.0 5 5 5 ns trac Minimum Recovery Time, Reset Inactive to Clock 5.0 5 5 5 ns tw Minimum Pulse Width, Clock 5.0 16 20 24 ns SWITCHING WAVEFORMS = |t PHL) a- Ge @ VI = TPL 0 or G VT tree VALID Date Vy VT Vy Clock __ GND GND tau th YH input and Output Threshold Voltage: Vr =50% Voc for HC, Vr 1.3V for HCT, Va = Vee for HC, 3V for HCT Clock ____ GND 1-800-AVSEMI 5-107 DV74HC164, DV74HCT164