Memory Module Specifications KVR16LE11K4/32 32GB (8GB 2Rx8 1G x 72-Bit x 4 pcs.) PC3L-12800 CL11 240-Pin ECC DIMM Kit DESCRIPTION SPECIFICATIONS ValueRAM's KVR16LE11K4/32 is a kit of four 1G x 72-bit (8GB) CL(IDD) 11 cycles DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 2Rx8, ECC, Row Cycle Time (tRCmin) 48.125ns (min.) low voltage, memory modules, based on eighteen 512M x 8-bit Refresh to Active/Refresh Command Time (tRFCmin) 260ns (min.) FBGA components per module. Total kit capacity is 32GB. The SPDs are programmed to JEDEC standard latency DDR3-1600 Row Active Time (tRASmin) 35ns (min.) timing of 11-11-11 at 1.35V or 1.5V. Each 240-pin DIMM uses Maximum Operating Power (Per module) (1.35V) = 2.041 W* gold contact fingers. The electrical and mechanical specifications are as follows: UL Rating 94 V - 0 Operating Temperature 0o C to 85o C FEATURES Storage Temperature -55o C to +100o C * JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply *Power will vary depending on the SDRAM. * VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) * 800MHz fCK for 1600Mb/sec/pin * 8 independent internal bank * Programmable CAS Latency: 11, 10, 9, 8, 7, 6 * Programmable Additive Latency: 0, CL - 2, or CL - 1 clock * 8-bit pre-fetch * Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] * Bi-directional Differential Data Strobe * Thermal Sensor Grade B * Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm 1%) * On Die Termination using ODT pin * Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C * Asynchronous Reset * PCB: Height 1.18" (30mm), double sided component Continued >> Document No. VALUERAM1420-001.A00 03/05/14 Page 1 MODULE DIMENSIONS: T E C H N O L O G Y 133.35 Units: millimeters 30.00 18.80 15.80 11.00 8.00 54.70 0.00 0.00 Document No. VALUERAM1420-001.A00 Page 2