Complex connector IDC type (power contact: crimping type) female connector for cable and panel PCL-G96RF( )( )+ For cable and panel IDC (1.27 mm), Crimping Sequence Configuration of product Part No. PCL-G 96 RF ( ) ( )+ TM Series name Type of key (See Note #1) Blank : None TM No. of contacts: 96 (20 in a block 1 : Key type 1 for signals, 68 in a block for signals 2 : Key type 2 and 8 in a block for power) Type of contact Others RM: 1.27 mm pitch signal contacts, Blank : Standard type IDC type, with strain relief, female A : Mounting hole diameter: 2.8mm (AWG#28 stranded flat cable) B : 68 contacts in a block for signals, AWG#30 stranded flat cable for IDC 24.13 29.5 12 MAX 96 84.5 91 33.6 (20 contacts in a block) 22.86 Polarity key 27 11 29 JAPAN 26 HONDA 9.5 TM 2.54 30 6.5 4.4 4.8 3.9 96 POS.#P8 POS.#P7 POS.#P2 POS.#P1 M3 95 (20 contacts in a block) (Dimension for tapped hole) POS.#1 Recommended panel cut-out dimensions POS.#2 (Panel thickness: t = 2 mm or less) POS.#19 2 3 POS.#20 10 10 2.54 103 2.54 POS.#1 4 POS.#68 (68 contacts in a block) 94.7 POS.#2 o3.3 POS.#67 (68 contacts in a block) 83.82 88 85.09 98.7 5 Cable housing Components TM Power contact Strain relief 5 Insulator Signal contact Mating connectors: PCL-G96RM( )+ (See Note #1) Power contacts: PCL-A-F( ) IDC tool: Locator plate: MLPT-0001A, Hand press: RPS-K4 (Refer to page Tool-16) Hand crimping tool: KP-PCL-346F( )N Through hole SMT Press-in IDC Extraction tool: AMQ-RT2 (Refer to page Tool-9) Wire Soldering Crimping wrapping Others Note 1: Male and female connectors can be mated each other with same key type. However, a female connector without key can be mated with a male connector with any key. Further, when trying to mate a male connector without key and a female connector with key, some adjacent contacts may create a short circuit.