7 Pin SIL 4 Tap TTL Compatible Active Delay Lines TAP DELAYS 5% or 2 nS 1.0 2.0 3.0 4.0 5.0 6.0 7.0 8.0 9.0 10.0 12.0 TOTAL DELAYS 5% or 2 nS Part Number *3 0.5 *8 1.0 *9 *12 *15 *18 28 32 36 40 48 EPA1190-4 EPA1190-6 EPA1190-9 EPA1190-12 EPA1190-15 EPA1190-18 EPA1190-28 EPA1190-32 EPA1190-36 EPA1190-40 EPA1190-48 0.5 1 1 1.5 TAP DELAYS 5% or 2 nS Part Number TOTAL DELAYS 5% or 2 nS 60 80 100 120 140 160 200 240 280 320 360 400 15 20 25 30 35 40 50 60 70 80 90 100 EPA1190-60 EPA1190-80 EPA1190-100 EPA1190-120 EPA1190-140 EPA1190-160 EPA1190-200 EPA1190-240 EPA1190-280 EPA1190-320 EPA1190-360 EPA1190-400 Whichever is greater. Delay times referenced from input to leading edges at 25C, 5.0V, with no load. *Delay times referenced from 1st tap 1st tap is the inherent delay: approx. 7 nS DC Electrical Characteristics Parameter Test Conditions VOH VOL VIK IIH High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current VCC = min. VIL = max. I OH = max VCC = min. VIH = min. I OL= max VCC = min. II = IIK VCC = max. VIN = 2.7V VCC = max. VIN = 5.25V IIL Low-Level Input Current VCC = max. VIN = 0.5V IOS Short Circuit Output Current VCC = max. VOUT = 0. (One output at a time) I CCH High-Level Supply Current VCC = max. VIN = OPEN I CCL Low-Level Supply Current VCC = max. VIN = 0 TRO Output Rise Time Td 500 nS (0.75 to 2.4 Volts) NH Fanout High-Level Output VCC = max. VOH = 2.7V NL Fanout Low-Level Output VCC = max. VOL = 0.5V Recommended Operating Conditions VCC VIH VIL IIK IOH IOL PW* d* TA Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature Schematic Min Max Unit 2.7 -40 0.5 -1.2V 50 1.0 -2 -100 V V V A mA mA mA 1 3 VCC INPUT 115 mA 115 mA 4 nS 20 TTL LOAD 10 TTL LOAD Max Unit 4.75 2.0 5.25 V V V mA mA mA % % C 0.8 -18 -1.0 20 40 0 40 +70 Input Pulse Test Conditions @ 25 C VCC 7 GROUND .200 Max. .820 Max. .350 Max. PCA EPA1190-4 Date Code Unit 3.2 110 2.0 1.0 100 5.0 .020 Typ. .020 Min. .010 Typ. .022 Typ. .100 Typ. Volts % nS MHz KHz Volts QAF-CSO1 Rev. B 8/25/94 DSA1190 Rev. A 2/5/96 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = 1/32 .XX = .030 .XXX = .010 6 OUTPUT 2 .100 Min. Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td 200 nS Pulse Repetition Rate @ Td > 200 nS Supply Voltage 5 Package Dimensions Min *These two values are inter-dependent. EIN PW TRI PRR 4 ELECTRONICS INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791