Dupline(R) Plug & Play Master Module Du line (R) Interface for Schneider (Telemecanique & Modicon) PLC Type G 3496 0007 Fieldbus Installationbus * Schneider (Telemecanique & Modicon) Slave * Plug and play: Automatic communication with specific PLC/Controllers * Built-in normal Dupline(R) Channel Generator * 128 I/O's and DC power supply on 3 wires * RS485 port for interfacing to control system * Split-I/O mode selectable (128 inputs and 128 outputs) * LED-indications for supply, Dupline(R) carrier and Comport TX * Galvaniccally isolated Com-port supplied by internal DC/DC converter Product Description G 3495 0007 is designed as a cost-effective solution for interfacing Dupline(R) I/O's to all Schneider PLCs - the Telemecanique and Modicon families. It performs three Ordering Key (R) functions: Dupline channel generator, power supply synchronization (enables 3-wire system with supply) and RS485 interface. G 3496 0007 700 (R) Type: Dupline H4-Housing Combined module Interface type DC supply Type Selection Supply PLC Interface Conformance Ordering no. 20-30 VDC Schneider, Telemecanique and Modicon. G 3496 0007 700 Input/Output Specifications Supply Specifications Power Output Output voltage Output current Short circuit protection Output voltage drop Dupline(R) carrier Output voltage Current Short circuit protection Scan time 128 channels 64 channels Communication Port Standard Connection Dielectric voltage Com-port-Dupline(R) Protocol Channel Configuration in PLC Baud rate Data bits Start bit Stop bit Parity Flow-control Pin assignment RS485 A B GND Power supply Operational voltage (Vin) Reverse polarity protection Current consumption Power dissipation Transient protection voltage Dielectric voltage Supply - Dupline(R) Supply - Com-port 20-30 VDC (pulsating) < 3.0 A @ 50C 4 A quick acting fuse < 1.0 V 8.2 V (pulsating) < 60 mA Yes 132.2 ms 69.8 ms RS485 9 pole female Sub-D 1 kVAC (rms) Unitelway V2 9600 8 1 Odd None 8 3 5 Overvoltage cat. III (IEC 60664) 20-30 VDC None < 150 mA + Power load <5W 800 V None 1 kVAC (rms) General Specifications Power ON delay Indication for Com-port TX Supply ON Dupline(R) carrier Environment Pollution degree Operating temperature Storage temperature Humidity (non-condensing) Mechanical resistance Shock Vibration Dimensions Material Weight Specifications are subject to change without notice (05.05.03) Dupline(R) is a registered trademark. A product of the CARLO GAVAZZI Group 2s LED, red LED, green LED, yellow 2 (IEC 60664) 0 to +50C (+32 to +122F) -50 to +85C (-58 to +185F) 20 to 80% 15 G (11 ms) 2 G (6 to 55 Hz) H4-Housing (See Technical Information) 100 g 1 Du line G 3496 0007 (R) Fieldbus Installationbus Mode of Operation The Dupline(R) Master Module (DMM) controls a 3-wire bus with signal, DC-power and common GND. The DMM is connected to a standard DCsupply, which it synchronizes with the Dupline(R) carrier signal before it is output to supply. The synchronization is necessary in order to enable the Dupline(R) and DC-supply to share the GND-wire. The Dupline(R) Master Module is a Dupline(R) Channel Generator with the function of a master. This means that the 128 Dupline(R) I/0's will be read/written by the DMM and then sentto the PLC. The DMM can run in two different modes - Normal mode and split I/O mode. In Normal mode, Dupline(R) operates as a peer-to-peer system, where the channel generator automatically establishes a connection between Dupline(R) inputs and Dupline(R) outputs which are coded to the same Dupline(R) address. If e.g. an Memory Mapping Sw.3 (R) Dupline Schneider, Teleme- Dupline Schneider, TelemeChannel canique & Modicon Channel canique & Modicon Read Write Read Write A1 MW0: X0 MW8: X0 E1 MW2: X0 MW10: X0 A2 MW0: X1 MW8: X1 F1 MW2: X8 MW10: X8 A3 MW0: X2 MW8: X2 G1 MW3: X0 MW11: X0 A4 MW0: X3 MW8: X3 H1 MW3: X8 MW11: X8 A5 MW0: X4 MW8: X4 I1 MW4: X0 MW12: X0 A6 MW0: X5 MW8: X5 J1 MW4: X8 MW12: X8 A7 MW0: X6 MW8: X6 K1 MW5: X0 MW13: X0 A8 MW0: X7 MW8: X7 L1 MW5: X8 MW13: X8 B1 MW0: X8 MW8: X8 M1 MW6: X0 MW14: X0 B8 MW0: X15 MW8: X15 N1 MW6: X8 MW14: X8 C1 MW1: X0 MW9: X0 O1 MW7: X0 MW15: X0 D1 MW1: X8 MW9: X8 P1 MW7: X8 MW15: X8 2 Consequently, a Dupline(R)-output can either be activated through the output-data received on DMM or by an active Dupline(R) input coded for the same Dupline(R)address. In "Split I/O" mode, the channel generator treats the Dupline(R) inputs and Dupline(R) outputs independently. If e.g. an input coded for B5 is activated, the DMM will make the information available for the PLC (like in normal mode), but it will not automatically activate the Dupline output(s) coded to B5. The Dupline(R) outputs are controlled exclusively through the output data received from the PLC. In this mode, up to 128 Dupline(R) inputs and 128 Dupline(R) outputs are available, since an input and an output coded to the same Dupline(R) address can operate independently. Dip-Switch Setting Table of the memory mapping to the PLC (R) input coded for B5 is activated, the output(s) coded for B5 will also be activated. Sw.4 Sw.5 Sw.6 On: Off: On: Off: On: Off: On: Off: Communication on Datalink address 4 and 5 Communication on Datalink address 6 and 7 Split I/O Channel Generator Mode Normal Dupline(R) Monostable Channel Generator Mode 64 Dupline(R) channels 128 Dupline(R) channels Maintain data to Dupline(R) receivers in case of communication failure Clear data to Dupline(R) receivers in case of communication failure after 75 Dupline(R) scans Specifications are subject to change without notice (30.11.00) Dupline(R) is a registered trademark. A product of the CARLO GAVAZZI Group Du line G 3496 0007 (R) Fieldbus Installationbus Pin Assignment DMM G34960007 9P D-SUB Male 8 (A) 3 (B) 5 (GND) Schneider (Telemecanique & Modicon) 8-pin mini-DIN Male (TER or AUX) 2 (DA) 1 (DB) 7 (GND) 5 4 3 2 1 9 8 7 6 8-pin Mini Din 9-pin D-shell 678 3 5 4 12 Accessories Cable Sub-D 9M/8 mini Din Installation Hints RS-232-SC1 Slow-flashing TX-LED Hardware fault Check the wiring. No Dupline(R) Carrier-LED Dupline(R) short circuit Short circuit between the two Dupline(R) wires. Additional Information Scope of supply 1 x Master Module Specifications are subject to change without notice (30.11.00) Dupline(R) is a registered trademark. A product of the CARLO GAVAZZI Group G3496 0007 700 3