V17
1
︳
CFM100M SERIES
100W MEDICAL&ITE
OPEN FRAME
AC-DC MODULES
WITH PFC
Features
* Universal Input Range 90 ~ 264VAC
* Medical and ITE Approved
* 3”x 5” Compact Size
* Less than 1 U high
* Industry Standard Pin Out
* Active PFC Meets EN61000-3-2
* High Efficiency up to 92%
* Meets CISPR/FCC Class B
* Remote Voltage Sense
* Over Voltage Protection
* Continuous Short Circuit Protection
* No Load Power Consumption<0.5W
* Meets 2MOPP
MODEL OUTPUT
VOLTAGE
MAX.
LOAD
MIN.
LOAD
RIPPLE &
NOISE
NOTE 1
VOLTAGE
ADJ. RANGE
VOLTAGE
ACCURACY
NOTE 2
LINE
REGULATION
NOTE 3
LOAD
REGULATION
NOTE 4
% EFF.
(Typ.)
NOTE 5
CFM100M050
5 V 20 A
0 A 2% 4.75~5.25 ±1% ±0.5% ±1% 83%
CFM100M075
7.5 V 13.4 A
0 A 2% 7.13~7.88 ±1% ±0.5% ±1% 87%
CFM100M090
9 V 11.2 A
0 A 1% 8.55~9.45 ±1% ±0.5% ±1% 89%
CFM100M120
12 V 8.4 A
0 A 1% 11.4~12.6 ±1% ±0.5% ±1% 89%
CFM100M150
15 V 6.7 A
0 A 1% 14.25~15.75
±1% ±0.5% ±1% 90%
CFM100M180
18 V 5.6 A
0 A 1% 17.1~18.9 ±1% ±0.5% ±1% 90%
CFM100M240
24 V 4.2 A
0 A 1% 22.8~25.2 ±1% ±0.5% ±1% 91%
CFM100M280
28 V 3.6 A
0 A 1% 26.6~29.4 ±1% ±0.5% ±1% 90%
CFM100M360
36 V 2.8 A
0 A 1% 34.2~37.8 ±1% ±0.5% ±1% 91%
CFM100M480
48 V 2.1 A
0 A 1% 45.6~50.4 ±1% ±0.5% ±1% 92%
Specifications are subject to change without notice.
V17
2
Specifications
CFM100M Series Derating Curve
INPUT SPECIFICATIONS:
Voltage …....………........…........................................... 90~264Vac
Frequency ………………………………………….……………..... 47 to 63Hz
Inrush Current ………………….……………................... 80A max. @240Vac
Leakage Current ………………………………………….…...…… 300uA max.
OUTPUT SPECIFICATIONS:
Hold-up Time ………………………………………………………... 16ms typ.
Short Circuit Protection ……….…….………… Hiccup mode(Auto Recovery)
Adjustment Range on Vout…………………………………………………. ±5%
Over Voltage Protection ………………………… Recycle AC input to restart
Temperature Coefficient ……………………..............................… ±0.05%/℃
GENERAL SPECIFICATIONS:
Isolation …………………………………………… Input to output = 5,656VDC
NOTE:
Operating Temperature ........................... -20 ~ ℃70℃ (see Derating Curve)
1. CFM100M050:Add a 0.1uF ceramic capacitor and 220uF E.L.
Storage Temperature ……………………………….........……........ -20 ~ 85℃
capacitor to output for Ripple & Noise measuring @20MHz BW.
Humidity ...................................................... 93% RH max. Non condensing
Other Model: Add a 0.1uF ceramic capacitor and a 10uF E.L. capacitor to
Cooling ……………………………………………………. Natural Convection
output for Ripple & Noise measuring @20MHz BW.
Switching Frequency ………………………............................. 90KHz Typical
2. Voltage accuracy is set at 100% rated load and 25℃ Ta.
MTBF ………….… MIL-HDBK-217F, GB, 25℃/115VAC …… 200Khrs min.
3. Line regulation is measured from high line to low line with full load.
Altitude ……………………..………………...………………………….. 3000m
4. Load regulation is measured from Full to 10% load.
Dimensions ………….. 5.000x3.000x1.050inches (127.00x76.20x26.67mm)
5. Typical efficiency at 230VAC and full load at 25℃.
Weight ………………………………………………………... 270g (0.6Pounds)
6. Standard input and output connectors wafer with LONG CHU P3060
SAFETY AND EMC:
series and mate with MOLEX housing 09-50-1031 and 09-50-1081 or
equivalent.
Emission and Immunity ………………. EN55024, EN61000-6-1, EN61204-3
7. DC output pin 1, 2, 3, 4: Vout (-), DC output pin 5, 6, 7, 8: Vout (+).
EN60601-1-2, EN61000-3-2 Class A, B, C, D, EN61000-3-3
EN55011 Class B, EN55022 Class B, FCC Part15 Class B
Safety ……….
IEC60601-1:2005, EN60601-1:2006, ANSI/AAMI ES60601-1:2005
IEC60950-1, EN60950-1, UL60950-1
CFM100M Series
All Dimensions are in inches[mm]
Tolerance: Inches:x.xxx= ±0.02
Millimeters:x.xx= ±0.5
4
5
6
7
8
1
2
3
ACL
ACN
LED
RS-
RS+
VR
0.224(5.70)
2.555(64.90)
3.000(76.20)
0.118(3.00)max
0.063(1.60)
1.050(26.67)max
0.224(5.70)
4.546(115.48)
5.000(127.00)
Typical at 25˚C, nominal line and 75% load, unless otherwise Specified
CFM100
M
0%
25%
50%
75%
100%
-20 -10 0 10 20 30 40 50 60 70
Ambient Temperature(C)
Rate Load (%)
20LFM(Natural Convection)
100LFM
