© PHOENIX CONTACT - 09/2009
101170_en_02
INTERFACE
EMG ...-DIO ...
Data sheet
1Description
Diode circuits perform various tasks in electrical, but
especially electronic control systems, such as:
Electrical decoupling of messages in fault signaling
systems
or
As spark-suppression diodes for limiting surge voltages
of inductive loads, such as solenoid valves, DC relays
or similar
In order to meet these requirements, diode modules are
available as "diode gates" with common negative and
positive polarity or as individual diodes.
NOTE:
Please note that there is no isolation between the individual diode paths within a module.
Make sure you always use the latest documentation.
It can be downloaded at www.phoenixcontact.net/download.
This data sheet is valid for all products listed on the following page:
Diode modules
EMG ...-DIO ...
101170_en_02 PHOENIX CONTACT 2
2Ordering data
3 Technical data
Diode module, can be individually wired
Description
Housing
width
Type Order No. Pcs./Pkt.
4 diodes, type 1 N 4007 22.5 mm EMG 22-DIO 4E 2950048 10
4 diodes, type 1 N 5408 22.5 mm EMG 22-DIO 4E-1N5408 2952790 10
8 diodes, type 1 N 4007 45 mm EMG 45-DIO 8E 2950103 5
8 diodes, type 1 N 5408 45 mm EMG 45-DIO 8E-1N5408 2949389 5
17 diodes, type 1 N 4007 90 mm EMG 90-DIO 17E 2954895 5
Diode module, positive polarity (common cathode)
Description
Housing
width
Type Order No. Pcs./Pkt.
4 diodes, type 1 N 5408 22.5 mm EMG 22-DIO 4P-1N5408 2952198 10
7 diodes, type 1 N 4007 22.5 mm EMG 22-DIO 7P 2950064 10
8 diodes, type 1 N 5408 45 mm EMG 45-DIO 8P-1N5408 2954879 5
14 diodes, type 1 N 4007 45 mm EMG 45-DIO14P 2950116 5
32 diodes, type 1 N 4007 90 mm EMG 90-DIO 32P 2954918 5
Diode module, negative polarity (common anode)
Description
Housing
width
Type Order No. Pcs./Pkt.
4 diodes, type 1 N 5408 22.5 mm EMG 22-DIO 4M-1N5408 2952211 10
7 diodes, type 1 N 4007 22.5 mm EMG 22-DIO 7M 2950077 10
8 diodes, type 1 N 5408 45 mm EMG 45-DIO 8M-1N5408 2954882 5
14 diodes, type 1 N 4007 45 mm EMG 45-DIO14M 2950129 5
32 diodes, type 1 N 4007 90 mm EMG 90-DIO 32M 2954934 5
Accessories
Description Type Order No. Pcs./Pkt.
Device marking label EMG-GKS 12 2947035 50
General data
Ambient temperature range -20°C +50°C
Rated insulation voltage according to EN 50178 300 V
Pollution degree according to EN 50178 2
Surge voltage category according to EN 50178 3, basic insulation
Mounting position Any
Installation Can be aligned without spacing
Height 55 mm
Length 75 mm
Connection data
Conductor cross-section, solid 0.2 mm² … 4 mm²
Conductor cross-section, stranded 0.2 mm² … 2.5 mm²
Conductor cross-section, AWG 24 - 12
Stripping length 8 mm
Connection method Screw connection
EMG ...-DIO ...
101170_en_02 3
PHOENIX CONTACT GmbH & Co. KG • 32823 Blomberg • Germany • Phone: +49 - 52 35 - 30 0
PHOENIX CONTACT • P.O.Box 4100 • Harrisburg • PA 17111-0100 • USA • Phone: +717-944-1300
www.phoenixcontact.com
4Circuit diagram
4.1 Diode module, can be individually wired
Figure 1 E.g., EMG 22-DIO 4E
4.2 Diode module, positive polarity
Figure 2 E.g., EMG 22-DIO 7P
4.3 Diode module, negative polarity
Figure 3 E.g., EMG 22-DIO 7M
Diode data for diode type 1 N 4007 EMG 22-DIO 4E, EMG 45-DIO 8E,
EMG 90-DIO 17E, EMG 22-DIO 7P,
EMG 22-DIO 7M
EMG 45-DIO14P, EMG 45-DIO14M,
EMG 90-DIO 32P, EMG 90-DIO 32M
Maximum operating voltage Umax 250 V AC 250 V AC
Peak reverse voltage per diode 1300 V 1300 V
Reverse current per diode 5 µA 5 µA
Conducting-state voltage per diode 0.8 V, approximately 0.8 V, approximately
Conducting-state current per diode
With single load
With simultaneous load
0.7 A
0.5 A
0.7 A
0.2 A
Diode data for diode type 1 N 5408 EMG 22-DIO 4E-1N5408,
EMG 22-DIO 4P-1N5408,
EMG 22-DIO 4M-1N5408
EMG 45-DIO 8E-1N5408,
EMG 45-DIO 8P-1N5408,
EMG 45-DIO 8M-1N5408
Maximum operating voltage Umax 250 V AC 250 V AC
Peak reverse voltage per diode 1000 V 1000 V
Reverse current per diode 10 µA 10 µA
Conducting-state voltage per diode 0.8 V, approximately 0.8 V, approximately
Conducting-state current per diode
With single load
With simultaneous load
1.5 A
1 A
1.5 A
0.3 A
Conformance/approvals
Conformance CE-compliant
Conformance with Low Voltage Directive (LVD) 2006/95/EC
Electronic equipment according to EN 50178
2
1
4
3
6
5
8
7
5
1
6
2
7
3
P
4
5
1
6
2
7
3
M
4