BD244, BD244A, BD244B, BD244C PNP SILICON POWER TRANSISTORS Designed for Complementary Use with the BD243 Series 65 W at 25C Case Temperature 6 A Continuous Collector Current B 1 10 A Peak Collector Current C 2 Customer-Specified Selections Available E 3 TO-220 PACKAGE (TOP VIEW) Pin 2 is in electrical contact with the mounting base. MDTRACA absolute maximum ratings at 25C case temperature (unless otherwise noted) RATING SYMBOL Collector-emitter voltage (RBE = 100 ) BD244B Collector-emitter voltage (IC = -30 mA) VCER -115 -45 V CEO Peak collector current (see Note 1) Continuous base current Continuous device dissipation at (or below) 25C case temperature (see Note 2) Continuous device dissipation at (or below) 25C free air temperature (see Note 3) Unclamped inductive load energy (see Note 4) Operating junction temperature range Storage temperature range Lead temperature 3.2 mm from case for 10 seconds NOTES: 1. 2. 3. 4. -60 V -80 -100 BD244C Continuous collector current V -90 BD244C BD244B Emitter-base voltage -70 BD244 BD244A UNIT -55 BD244 BD244A VALUE VEBO -5 IC -6 V A ICM -10 A IB -3 A Ptot 65 W Ptot 2 W 1/2LIC2 62.5 mJ C Tj -65 to +150 Tstg -65 to +150 C TL 250 C This value applies for tp 0.3 ms, duty cycle 10%. Derate linearly to 150C case temperature at the rate of 0.52 W/C. Derate linearly to 150C free air temperature at the rate of 16 mW/C. This rating is based on the capability of the transistor to operate safely in a circuit of: L = 20 mH, IB(on) = -0.4 A, RBE = 100 , VBE(off) = 0, RS = 0.1 , VCC = -20 V. JUNE 1973 - REVISED SEPTEMBER 2002 Specifications are subject to change without notice. 1 BD244, BD244A, BD244B, BD244C PNP SILICON POWER TRANSISTORS electrical characteristics at 25C case temperature PARAMETER V(BR)CEO ICES ICEO IEBO hFE V CE(sat) VBE hfe |hfe | Collector-emitter breakdown voltage TEST CONDITIONS IC = -30 mA MIN IB = 0 (see Note 5) BD244 -45 BD244A -60 BD244B -80 BD244C -100 TYP MAX V VCE = -55 V VBE = 0 BD244 -0.4 Collector-emitter VCE = -70 V VBE = 0 BD244A -0.4 cut-off current VCE = -90 V VBE = 0 BD244B -0.4 VCE = -115 V VBE = 0 BD244C -0.4 Collector cut-off VCE = -30 V IB = 0 BD244/244A -0.7 current VCE = -60 V IB = 0 BD244B/244C -0.7 VEB = -5 V IC = 0 Forward current VCE = -4 V IC = -0.3 A transfer ratio VCE = -4 V IC = -3 A IB = -1 A IC = -6 A VCE = -4 V IC = -6 A Emitter cut-off current Collector-emitter saturation voltage Base-emitter voltage Small signal forward current transfer ratio Small signal forward current transfer ratio UNIT mA mA -1 mA (see Notes 5 and 6) -1.5 V (see Notes 5 and 6) -2 V 30 (see Notes 5 and 6) 15 VCE = -10 V IC = -0.5 A f = 1 kHz 20 VCE = -10 V IC = -0.5 A f = 1 MHz 3 NOTES: 5. These parameters must be measured using pulse techniques, tp = 300 s, duty cycle 2%. 6. These parameters must be measured using voltage-sensing contacts, separate from the current carrying contacts. thermal characteristics MAX UNIT RJC Junction to case thermal resistance PARAMETER MIN TYP 1.92 C/W RJA Junction to free air thermal resistance 62.5 C/W MAX UNIT resistive-load-switching characteristics at 25C case temperature PARAMETER TEST CONDITIONS MIN ton Turn-on time IC = -1 A IB(on) = -0.1 A IB(off) = 0.1 A toff Turn-off time VBE(off) = 3.7 V RL = 20 tp = 20 s, dc 2% 0.3 s 1 s Voltage and current values shown are nominal; exact values vary slightly with transistor parameters. 2 TYP JUNE 1973 - REVISED SEPTEMBER 2002 Specifications are subject to change without notice. BD244, BD244A, BD244B, BD244C PNP SILICON POWER TRANSISTORS TYPICAL CHARACTERISTICS TYPICAL DC CURRENT GAIN vs COLLECTOR CURRENT TCS634AH VCE = -4 V TC = 25C tp = 300 s, duty cycle < 2% 100 10 1*0 -0*1 -1*0 -10 TCS634AE -10 VCE(sat) - Collector-Emitter Saturation Voltage - V hFE - DC Current Gain 1000 COLLECTOR-EMITTER SATURATION VOLTAGE vs BASE CURRENT IC = -300 mA IC = -1 A IC = -3 A IC = -6 A -1*0 -0*1 -0*01 -0*001 IC - Collector Current - A -0*01 -0*1 -1*0 -10 IB - Base Current - A Figure 1. Figure 2. BASE-EMITTER VOLTAGE vs COLLECTOR CURRENT -1*2 TCS634AF VBE - Base-Emitter Voltage - V VCE = -4 V TC = 25C -1*1 -1*0 -0*9 -0*8 -0*7 -0*6 -0*1 -1*0 -10 IC - Collector Current - A Figure 3. JUNE 1973 - REVISED SEPTEMBER 2002 Specifications are subject to change without notice. 3 BD244, BD244A, BD244B, BD244C PNP SILICON POWER TRANSISTORS MAXIMUM SAFE OPERATING REGIONS MAXIMUM FORWARD-BIAS SAFE OPERATING AREA IC - Collector Current - A -100 SAS634AD tp = 300 s, d = 0.1 = 10% tp = 1 ms, d = 0.1 = 10% tp = 10 ms, d = 0.1 = 10% DC Operation -10 -1*0 -0*1 BD244 BD244A BD244B BD244C -0*01 -1*0 -10 -100 -1000 VCE - Collector-Emitter Voltage - V Figure 4. THERMAL INFORMATION MAXIMUM POWER DISSIPATION vs CASE TEMPERATURE TIS633AB Ptot - Maximum Power Dissipation - W 80 70 60 50 40 30 20 10 0 0 25 50 75 100 125 150 TC - Case Temperature - C Figure 5. 4 JUNE 1973 - REVISED SEPTEMBER 2002 Specifications are subject to change without notice.