5.7" (145mm) BLDC Thru Flow Blower Blower Data 400 WATT, 240 VOLT Part Number Standard Flow Unit of Measure 117629 E* Stages 117630 E* 1 2 Vacuum, Max. (Sealed Vacuum) in. H2O 28 47 mBar 69 117 Pressure, Max. (Sealed Pressure) in. H2O 31 50 mBar 77 124 Flow Rate, Max. (Open Flow) CFM L/sec 67 32 65 31 Length (Dimension "I" above) inches .69 1.60 mm 17.53 40.64 Length (Dimension "L" above) Air Flow inches 3.21 4.12 mm 81.53 104.65 Typical Performance Points Pressure 0 CFM in. H2O 31.1 50.5 10 CFM in. H2O 26.8 45.4 20 CFM in. H2O 23.8 40.9 30 CFM in. H2O 20.5 33.7 40 CFM in. H2O 15.8 25.3 50 CFM in. H2O 10.0 16.0 60 CFM in. H2O 4.4 6.46 70 CFM in. H2O *These part numbers are available through AMETEK Rotron distributors. See page 54 for distributor information. NOTES: Nominal input voltage: 240 Volts AC RMS +/- 10%, 60Hz Input current: 5 amps AC RMS maximum Temperature: Working Air: 0o C to 50C, Ambient Air: 0o C to 50C, Storage Air: -40o C to 85C Dielectric Testing: 1500 volts AC RMS 60Hz applied for one second between input pins and ground, 3mA leakage max. Speed Control: E (Electrical): Pulse Width Modulation or Analog input voltage (User Supplied), 0 to 10 Volts DC Nominal, 10mA Maximum, 3 to 15 volts DC Maximum. Access to sensitivity adjustment for 0-10 VDC speed control. (Ref. pin connection) M (Mechanical): A potentiometer is available for speed control of the blower. The potentiometer can be preset for a specific speed. Access to speed adjustment. 34 5.7/400TFBHV99 5.7" (145mm) BLDC Thru Flow Blower 400 WATT, 240 VOLT Regulatory Agency Certification: Underwriters Laboratories, Inc. is qualified per UL507 under File E-94403; Canadian Standards Association is qualified per C22.2#113 under File LR 43448. Miscellaneous: Intake & exhaust tubes, all cooling ducts and vents must not be obstructed. Intake and exhaust are free of grease, oil, or foreign particles. Amp housing #350809-1 (to be supplied by customer), mates with post header assembly. This document is for informational purposes only and should not be considered as a binding description of the products or their performance in all applications. The performance data on this page depicts typical performance under controlled laboratory conditions, data is corrected to 0.075 lb./ft3 air density (29.92" Hg @ 70 F.). Actual performance will vary depending on the operating environment and application. AMETEK Rotron products are not designed for use with volatile, hazardous or corrosive gases. Blower housings are not sealed, slight air/gas leakage will occur. AMETEK Rotron products are not designed for and should not be used in medical life support applications. AMETEK reserves the right to revise its products without notification. 35 5.7/400TFBHV99