34
Part Number
Standard Flow
Blower Data Unit of
117629 E*117630 E*
Stages
Measure
12
Vacuum, Max. (Sealed Vacuum) in. H2O28 47
mBar 69 117
Pressure, Max. (Sealed Pressure) in. H2O31 50
mBar 77 124
Flow Rate, Max. (Open Flow) C FM 6 7 6 5
L/sec 32 31
Length (Dimension “I” above) inches .69 1.60
mm 17.53 40.64
Length (Dimension “L” above) inches 3.21 4.12
mm 81.53 104.65
Typical Performance Points
Air Flow Pressure
0 CFM in. H2O 31.1 50.5
10 CFM in. H2O 26.8 45.4
20 CFM in. H2O 23.8 40.9
30 CFM in. H2O 20.5 33.7
40 CFM in. H2O 15.8 25.3
50 CFM in. H2O 10.0 16.0
60 CFM in. H2O 4.4 6.46
70 CFM in. H2O
NOTES:
Nominal input voltage: 240 Volts AC RMS +/- 10%, 60Hz
Input current: 5 amps AC RMS maximum
Temperature: Working Air: 0o C to 50°C, Ambient Air: 0o C to 50°C, Storage Air: -40o C to 85°C
Dielectric T esting: 1500 volts AC RMS 60Hz applied for one second between input pins and ground, 3mA leakage max.
Speed Control: E (Electrical): Pulse Width Modulation or Analog input voltage (User Supplied), 0 to 10 Volts DC Nominal, 10mA Maximum, 3 to 15 volts DC
Maximum. Access to sensitivity adjustment for 0-10 VDC speed control. (Ref. pin connection)
M (Mechanical): A potentiometer is available for speed control of the blower. The potentiometer can be preset for a specific speed. Access to speed adjustment.
5.7” (145mm) BLDC Thru Flow Blower 400 WATT, 240 VOLT
5.7/400TFBHV99
*These part numbers are available through AMETEK Rotron distributors. See page 54 for distributor information.
35
Regulatory Agency Certification: Underwriters Laboratories, Inc. is qualified per UL507 under File E-94403; Canadian Standards Association is qualified per
C22.2#113 under File LR 43448.
Miscellaneous: Intake & exhaust tubes, all cooling ducts and vents must not be obstructed. Intake and exhaust are free of grease, oil, or foreign particles. Amp
housing #350809-1 (to be supplied by customer), mates with post header assembly.
This document is for informational purposes only and should not be considered as a binding description of the products or their performance in all applications. The
performance data on this page depicts typical performance under controlled laboratory conditions, data is corrected to 0.075 lb./ft3 air density (29.92” Hg @ 70° F.).
Actual performance will vary depending on the operating environment and application. AMETEK Rotron products are not designed for use with volatile, hazardous or
corrosive gases. Blower housings are not sealed, slight air/gas leakage will occur. AMETEK Rotron products are not designed f or and should not be used in medical
life support applications. AMETEK reserves the right to revise its products without notification.
5.7” (145mm) BLDC Thru Flow Blower 400 WATT, 240 VOLT
5.7/400TFBHV99
