60 9CRLA type High Static Pressure Long Life Counter Rotating Fan Features High Static Pressure 3 This fan delivers a maximum airflow of 2.1 m /min and maximum static pressure of 1,400 Pa. The maximum static pressure has increased by approximately 40% compared with our current model.* Long Service Life With an expected life of 100,000 hours (about 11 years) of continuous operation, this fan contributes to longer maintenance-free operating periods for devices. High Energy Efficiency and Low Noise The PWM control function enables the external control of fan speed, contributing to lowering noise and improving energy efficiency of devices. * The San Ace 60L 9CRL type 60 x 60 x 76 mm Long Life Counter Rotating Fan (model no.: 9CRL0612P0G001). 60 x 60 x 76 mm Specifications The models listed below have pulse sensors with PWM control function. Operating Operating PWM -1 SPL Rated voltage voltage range duty cycle* Rated current Rated input Rated speed [min ] Max. airflow Max. static pressure temperature 3 [V] [A] [W] Inlet Outlet [m /min] [CFM] [Pa] [inchH2O] [dB(A)] [V] [%] [C] Model no. 9CRLA0612P0G001 10.8 to 13.2 12 9CRLA0612P0G003 100 3.0 36.0 16500 17800 2.1 74.1 1400 5.62 70 20 0.4 4.8 5000 5400 0.64 22.6 128 0.51 43 100 3.0 36.0 16500 17800 2.1 74.1 1400 5.62 70 20 0.4 4.8 5000 5400 0.64 22.6 0.51 43 128 Expected life [h] -20 to +70 100000/60C * PWM frequency: 25 kHz. Fan does not rotate when PWM duty cycle is 0%. Models with the following sensor specifications are also available as options: Without sensor Lock sensor Common Specifications Material Frame: Aluminum (Black coating), Impeller: Plastic (Flammability: UL 94V-1) Expected life Refer to specifications (L10 life: 90% survival rate for continuous operation in free air at 60C, rated voltage) Motor protection system Current blocking function and reverse polarity protection Dielectric strength Sound pressure level (SPL) Operating temperature Storage temperature Lead wire 50/60 Hz, 500 VAC, for 1 minute (between lead wire conductors and frame) At 1 m away from the air inlet Refer to specifications (Non-condensing) -30 to +70C (Non-condensing) Inlet: Red - Black Sensor Yellow Control Brown Outlet: Orange - Gray Sensor Purple Control White Mass Approx. 310 g PWM Duty Speed Characteristics Example Airflow - Static Pressure Characteristics PWM duty cycle 6 Operating voltage range (Pa) 1600 (inch H2O) 12 VDC 6 PWM duty cycle 100% 1400 4 1000 3 2 1 0 800 600 400 50% 20% 0 18000 10.8 V/12 V/ 13.2 V 1400 1 0.5 10 20 3 2 30 1.5 2 40 50 60 70 80 Airflow 9CRLA0612P0G001 9CRLA0612P0G003 3 2.5 (m /min) (CFM) 0 14000 600 -1 Outlet side 10000 8000 Inlet side 6000 400 4000 200 0 17800 min-1 16500 min 12000 800 0 Voltage: 12 VDC PWM frequency: 25 kHz 16000 4 1000 1 200 0 -1 (min ) PWM duty cycle 100% 5 1200 Static pressure Static pressure 5 1200 (Pa) 1600 Speed (inch H2O) 2000 0.5 1 1.5 3 2.5 (m /min) 2 10 20 30 40 50 60 70 Airflow 9CRLA0612P0G001 9CRLA0612P0G003 80 (CFM) 100 (%) 0 PWM duty cycle 9CRLA0612P0G001 9CRLA0612P0G003 PWM Input Signal Example Input signal waveform VIH VIH = 4.75 to 5.25 V VIL = 0 to 0.4 V PWM duty cycle (%) = T1 x100 T PWM frequency 25 (kHz) = 1 T Current source (Isource) = 5 mA max. (when control voltage is 0 V) Current sink (Isink) = 5 mA max. (when control voltage is 5.25 V) VIL Control terminal voltage = 5.25 V max. (when control terminal is open) T1 When the control terminal is open, fan speed is the same as when PWM duty cycle is 100%. T Either TTL input, open collector or open drain can be used for PWM control input signal. Example of Connection Schematic DC fan input voltage Inside of DC fan 10 k Control 22 20 k Isource PWM input signal Isink - Specifications for Pulse Sensors Output circuit: Open collector Output waveform (Need pull-up resistor) In case of steady running Inside of DC fan Sensor (One revolution) T0 Pull-up resistor Pull-up voltage Ic - Sensor output (VCE) T1 VCE = +13.8 V max. Ic = 10 mA max. [VOL = VCE (SAT) = 1.0 V max.] T2 T3 T1 to 4 (1/4) T0 T1 to 4 (1/4) T0=60/4N (s) -1 N = Fan speed (min ) T4 VOH VOL 0V Dimensions (unit: mm) Outlet side Inlet side 760.5 4-o4.30.3 Mounting hole 300 40.3 600.5 40.3 4-o4.30.3 Mounting hole 500.3 +50 0 500.3 600.5 (10) Lead wire (10) 300 Rotating direction +50 0 Model no.: 9CRLA0612P0G001 AWG 26 UL 1430 Model no.: 9CRLA0612P0G003 AWG 26 UL 1430 Sensor Control AWG 28 UL 1061 Airflow direction Rotating direction Reference Dimensions of Mounting Holes and Vent Opening (unit: mm) Inlet side, Outlet side 59 500.3 59 29.7 4-o4.5 50 0.3 62 . 7 29.7 Notice Please read the "Safety Precautions" on our website before using the product. The products shown in this catalog are subject to Japanese Export Control Law. Diversion contrary to the law of exporting country is prohibited. For protecting fan bearings against electrolytic corrosion near strong electromagnetic noise sources, we provide effective countermeasures such as Electrolytic Corrosion Proof Fans and EMC guards. Contact us for details. 3-33-1, Minami-Otsuka, Toshima-ku, Tokyo 170-8451, Japan TEL: +81 3 5927 1020 https://www.sanyodenki.com The names of companies and/or their products specified in this catalog are the trade names, and/or trademarks and/or registered trademarks of such respective companies. "San Ace" is a trademark of SANYO DENKI CO.,LTD. CATALOG No. C1083B002 `18.5 Specifications are subject to change without notice.