© 2013 Microsemi Corporation. All rights reserved.
FlashPro Lite Device Programmer
Quickstart Card
This quickstart card applies only to the FlashPro Lite device programmer.
Kit Contents
Software Installation
If you are already using Libero® System-on-Chip (SoC) software, you have the FlashPro software
installed as part of this software. If you are using the FlashPro Lite device programmer for
standalone programming or on a dedicated machine, download and install the latest release of the
FlashPro software from the Microsemi SoC Products Group website. The installation will guide you
through the setup. Complete the software installation before connecting the FlashPro Lite device
programmer to your PC. The installation will ask you “Will you be using FlashPro Lite or FlashPro
programmer via parallel port?”, answer “Yes”.
Software releases: www.microsemi.com/soc/download/program_debug/flashpro.
Hardware Installation
1. Connect the programmer to a parallel printer port on your PC. Connect one end of the IEEE 1284
cable to the programmer’s co nnector. Plug the other end of the cable into your parallel printer
port and tighten the screws. You should not have any licensing dongles connected between the
parallel port and cable. Your port settings must be EPP or bidirectional. Microsemi also supports
ECP mode with FlashPro v2.1 software and newer.
2. Verify that you are connected to the correct parallel port on your computer. Microsemi
recommends that you dedicate a port to the programmer. Connecting to a serial port or a third-
party card can damage the programmer. This type of damage is not covered by the warranty.
3. Connect the FlashPro Lite ribbon cable to the programming header and turn the target board on.
Quantity Description
1 FlashPro Lite programmer standalone unit
1 Ribbon cable for FlashPro Lite
1 IEEE 1284 parallel port cable
50200200-1/2.13
FlashPro Lite Device Programmer Quickstart Card
Common Issues
If you see two blinking LEDs on the programmer after you have connected the programmer to the
parallel port, make sure the parallel port cable is connected firmly to the PC parallel port. For more
information, refer to the FlashPro Software and Hardware Installation Guide and the “Known
Issues and Workarounds” section of the FlashPro software release notes:
www.microsemi.com/soc/download/program_debug/flashpro.
Documentation Resources
For further FlashPro software and FlashPro Lite device programmer information, including user's
guide, installation guide, tutorial, and application notes, refer to the FlashPro software page:
www.microsemi.com/soc/products/hardware/program_debug/flashpro.
Technical Support and Contacts
Technical support is available online at www.microsemi.com/soc/support and by email at
soc_tech@microsemi.com.
Microsemi SoC Sales offices, including Representatives and Distributors, are located worldwide. To
find your local representative visit www.microsemi.com/soc/company/contact.
