Magnetic Proximity Sensors (Hall Effect) MP1014 Sensors Digital Hall-effect position sensor in low-profile flange-mount housing Description The MP1 Series sensors are one-piece non-contact solid-state position sensors. The sensors operate through the use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a sinking current output. Features Typical Applications Solid state reliability South pole sensitive Unipolar device RoHS compliant Low profile design IP65 Door position & interlock Limit switch Flow/speed Home security Pedal switch Environmental Specifications -40 C to 85 C (-40 F to 185 F) -40 C to 100 C (-40 F to 212 F) IP65 Operating Temperature StorageTemperature Ingress Protection Electrical Specifications Operating Supply Voltage (MP101401) Operating Supply Voltage (MP101402) Supply Current Output Current (Sink) Maximum Reverse Voltage (MP101401) Maximum Reverse Voltage (MP101402) Pull-Up Resistor 4.5 to 18 VDC 4.5 to 24 VDC 3.0 mA typ., 5.2 mA max. 20 mA max. 18 VDC 15 VDC See chart Mechanical Specifications Housing Material Glass-reinforced nylon plastic Products Part Number MP101401 MP101402* *Not commonly stocked Leads 24 AWG x 314 mm 24 AWG x 314 mm Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be connected between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable. Recommended External Pull-Up Resistor Volts DC Ohms 5 1k 9 1.8k www.cherryswitches.com Page 1 of 2, last update 2014-10-29, Specifications subject to change without notice. 12 2.4k 15 3k 24 3k Open Collector Sinking Block Diagram Dimensions mm (inches) www.cherryswitches.com Page 2 of 2, last update 2014-10-29, Specifications subject to change without notice. Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: CHERRY: MP101401