www.cherryswitches.com
Page 1 of 2, last update 2014-10-29, Specifications subject to change without notice.
Magnetic Proximity Sensors (Hall Effect)
MP1014 Sensors
Digital Hall-effect position sensor
in low-profile flange-mount housing
Description
The MP1 Series sensors are one-piece non-contact solid-state position sensors. The sensors operate through the use of Hall
Effect technology with magnetic fields generated by permanent magnets. They provide a sinking current output.
Features
Typical Applications
Solid state reliability
South pole sensitive
Unipolar device
RoHS compliant
Low profile design
IP65
Door position & interlock
Limit switch
Flow/speed
Home security
Pedal switch
Environmental Specifications
Operating Temperature
-40 °C to 85 ⁰C (-40 ⁰F to 185 ⁰F)
StorageTemperature
-40 °C to 100 ⁰C (-40 ⁰F to 212 ⁰F)
Ingress Protection
IP65
Electrical Specifications
Operating Supply Voltage (MP101401)
4.5 to 18 VDC
Operating Supply Voltage (MP101402)
4.5 to 24 VDC
Supply Current
3.0 mA typ., 5.2 mA max.
Output Current (Sink)
20 mA max.
Maximum Reverse Voltage (MP101401)
18 VDC
Maximum Reverse Voltage (MP101402)
15 VDC
Pull-Up Resistor
See chart
Mechanical Specifications
Housing Material
Glass-reinforced nylon plastic
*Not commonly stocked
Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be
connected between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable.
Recommended External Pull-Up Resistor
Volts DC
5
9
12
15
24
Ohms
1k
1.8k
2.4k
3k
3k
Products
Part Number
Leads
MP101401
24 AWG x 314 mm
MP101402*
24 AWG x 314 mm
www.cherryswitches.com
Page 2 of 2, last update 2014-10-29, Specifications subject to change without notice.
Open Collector Sinking Block Diagram
Dimensions mm (inches)
