wiecon
wiecon
PCB
314
Pluggable PC board connectors
with pin-strip headers
Pluggable connectors provide a simple
2-piece mateable connection between an
external connector and the printed circuit
board.
System features
❐easy-to-operate screw termination
❐installation and maintenance friendly
❐quick disconnect
❐pole configurations from 2 to 24 poles
❐clear, straigthforward connection
❐mating in both horizontal and
vertical orientations to the printed
circuit board
❐clamping body always with wire
guard
Variety of types
❐spacings: (3.5/7/5/10) mm
❐2 to 24pole
❐terminal strip headers with vertical
or horizontal solder pins
❐
solder pin diameters available in: 0.8 mm,
1 mm and 1.3 mm others are on request
Marking
❐
smudge-proof inkjet marking directly
on the plug
❐clear, easily legible marking
❐custom marking possible, consult
factory
❐cost-effective marking directly on the
plug
Abbreviations for plastic materials:
PA 66/6 = Polyamide 66/6
PC = Polycarbonate
PBT = Polybutylenterephthalate
Material
Insulating housings:
❐use of high-quality polycarbonate
for its excellent electrical, mechanical
and chemical characteristics
(see
facts
& DATA)
Metal parts:
❐made of special alloys and/or
special surface platings
❐minimum feed through resistance
❐high corrosion resistance
❐secure, consistent clamping function
❐clamping body: nickel-plated brass
❐clamping screw: steel, zinc-plated and
dichromated
❐plug contact of type 8142 and ST 29:
tin-plated bronze
plug contact of type 8543:
nickel-plated brass
❐wire guard: tin-plated bronze
Pin-strip headers:
❐
Insulating part: made from high-quality
Polyamide 66/6
❐glass-fibre reinforcement for
dimensional stability
❐Metal parts:
contact pin: tin plated brass
Note:
The information regarding cross
sectional areas and connection types
pertains to connections without
ferrules.
The indicated rated current pertains
to the maximum load of the
PC board connector with a connected
wire of the indicated rated cross section.
The rated voltage is indicated as per
DIN VDE 0110 part 1 (IEC 60 664-1)
– insulation coordination for electrical
material in low voltage application –
and refers to the delivered state of
the PC board connector.
Before the PC board is fitted with
connectors, an appropriate PC board
must be selected and dimensioned
accordingly (e.g. regarding tracking
resistance of the printed circuit board,
distances of the leads and solder joints).
Furthermore, the ambient conditions
under which the device is to be used
(pollution degree) must be considered.
The indicated rated voltages will be valid
for the complete module only if the
printed circuit board and its connectors
are correctly and carefully matched to
each other.