SCOPE: 100mA CMOS SWITCHED-CAPACITOR VOLTAGE CONVERTER 1.5V TO 8V
Device Type Generic Number
01 MAX665M(x)/883B
Case Outline(s). The case outlines shall be designated in Mil-Std-1835 and as follows:
Outline Letter Mil-Std-1835 Case Outline Package Code
JA GDIP1-T8 or CDIP2-T8 8 LEAD CERDIP J8
Absolute Maximum Ratings
Supply Voltage (V+ to GND, or GND to OUT) .........…............................................. +8.5V
LV Input Voltage .....................................................….................. OUT -0.3V to V+ +0.3V
FC and OSC Input Voltages ....... (the least negative of OUT -0.3V or V+ -6V) toV+ +0.3V
OUT and V+ Continuous Output Current ....................…......................................... 120mA
Output Short-circuit Duration to GND 1/ ..........................…...................................... 1 sec
Lead Temperature (soldering, 10 seconds) ................................…............................... +300°C
Storage Temperature ...............................................................…................... -65°C to +160°C
Continuous Power Dissipation .................................................….............................TA=+70°C
8 lead CERDIP(derate 8.0mW/°C above +70°C) ....................................…................ 640mW
Junct ion Temper ature, TJ ..........................................................................….............. +150°C
Thermal Resistance, Junction to Case, ΘJC: ...........................................…............... 55°C/W
Thermal Resistance, Junction to Ambient, ΘJA: .....................................…............ 125°C/W
Recommended Operating Conditions.
Ambient Operating Range (TA) ................................................................ -55°C to +125°C
Inverter mode V+ to GND .................................................................. +1.5V dc to +8.0V dc
Doubler mode GND to VOUT .............................................................. +2.5V dc to +8.0V dc
NOTE 1: OUT may be shorted to GND for 1 sec without damage only if the input supply is limited to less
than 200mA, but shorting OUT to V+ may damage the device and should be avoided. Also, for
temperatures above +85°C, OUT must not be shorted to GND or V+, even instantaneously, or
device damage may result.
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device.
These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those indicated in the operational section s of the sp ecifica tions is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
---------------------------- Electrical Characteristics of MAX665/883B 19-0470 Rev. B
Page 2 of 5