Smart-UPSTM Installation Guide 750/1000/1500/2200/3000 VA 120/230 Vac 500 VA 100 Vac Tower Important Safety Messages Read the instructions carefully to become familiar with the equipment before trying to install, operate, service or maintain it. The following special messages may appear throughout this manual or on the equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a procedure. The addition of this symbol to a Caution product safety label indicates that an electrical hazard exists which will result in personal injury if the instructions are not followed. The following safety messages may appear throughout this manual to warn of potential hazards. CAUTION CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage and minor or moderate injury. CAUTION CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage. Safety and General Information Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage. Read the Safety Guide supplied with this unit before installing the UPS. * Adhere to all national and local electrical codes. * This UPS is intended for indoor use only. * Do not operate this UPS in direct sunlight, in contact with fluids, or where there is excessive dust or humidity. * Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation. * The battery typically lasts for two to five years. Environmental factors impact battery life. Elevated ambient temperatures, poor quality utility power, and frequent short duration discharges will shorten battery life. * Connect the UPS power cable directly to a wall outlet. Do not use surge protectors or extension cords. * The equipment is heavy. Always practice safe lifting techniques adequate for the weight of the equipment. * The model and serial numbers are located on a small, rear panel label. For some models, an additional label is located on the chassis under the front bezel. * Always recycle used batteries. * Recycle the package materials or save them for reuse. Inventory All models 120/230 Vac models (1) Documentation CD (1) 120/230 Vac models (1) PowerChute software CD (1) (1) 230 Vac models (2) 2200/3000 VA models (1) 2200/3000 VA models (1) 2200/3000 VA models (1) Rear panel features 500 VA to 1500 VA models 1000/1500 VA 100 Vac 1000/1500 VA 120 Vac 1000/1500 VA 230 Vac G RO UP 1 G R O UP 1 su0327b 750 VA 230 Vac su0326b 500 VA 100 Vac 750 VA 100/120 Vac su0325c 1 2 3 4 5 6 7 8 2 USB port RJ45 connector - serial UPS monitoring port Chassis ground screw SmartSlot for optional NMC accessory card Circuit breaker/Overload protection UPS input Outlets Internal or external battery connector Smart-UPS 750/1000/1500/2200/3000 VA 120/230 Vac 500 VA 100 Vac Tower su0328c Rear panel features 2200 VA / 3000 VA models 2200/3000 VA 100 Vac 3000 VA 120 Vac 2200 VA 120 Vac 2200/3000 VA 230 Vac GR O U P 1 GR O U P 1 su0351a su0330b su0329a GROUP 1 1 USB port 2 RJ45 connector - serial UPS monitoring port 3 Chassis ground screw 4 SmartSlot for optional NMC accessory card 5 Circuit breaker/Overload protection 6 UPS input 7 Outlets 8 EPO connector Installation 2200/3000 VA models Remove the bezel su0352b su0355a 500/750/1000/1500 VA models Connect the battery su0354a Insert the battery connector into the battery jack and push firmly. A snap will be felt as the connector partially engaes the jack. A second snap will be felt as the connector securely seats in the battery jack. Smart-UPS 750/1000/1500/2200/3000 VA 120/230 Vac 500 VA 100 Vac Tower 3 Electrical connections CAUTION RISK OF EQUIPMENT DAMAGE * Adhere to all national and local electrical codes. * Wiring should be performed by qualified electrician. * Always connect the UPS to a grounded outlet. Failure to follow these instructions can result in equipment damage s u0 44 1a Plug type and connector locations may vary. Display panel features 1 2 3 4 5 6 7 8 9 Online LED UPS ON/OFF key On Battery LED Fault LED Replace Battery LED Display interface UP/DOWN arrow keys ENTER key ESC key APC by Schneider Electric su0343a Controlled outlet groups Some UPS models have one bank of outlets that can function as a controlled group. Use the display interface to configure the controlled outlet features, navigate to: Main Menu > Control > Outlet1 Control. Refer to Rear panel features on pages 2 and 3 for model specific outlet groups. Select models are ENERGY STAR(R) qualified. For more information go to www.apc.com/site/recycle/index.cfm/energy-efficiency/energy-star/ (c) 2013 APC by Schneider Electric. APC, the APC logo, and Smart-UPS are owned by Schneider Electric Industries S.A.S., or their affiliated companies. All other trademarks are property of their respective owners. EN 990-3535D-002 05/2013 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Schneider Electric: SMT1500X448