Phone 707-778-6311 • Fax 707-778-6401 • E-mail 73024.2314@compuserve.com • Website http://www.schurterinc.com
COMBI
FIT
continued
Printed circuit board mounting
Panel mounting
Order Numbers
Stable snap feet requires
minimal insertion force Module must lay flat on the
pcb when soldering (see
diagram below)
0.5 Nm torque required for
screws
Insertion
from behind
“Sandwich”
mounting with
split enclosure panels
Screw-on mount uses self-
tapping screws
For 2-pole inlet/switch,2-pole
inlet/fuseholder and inlet/outlet For 1-pole inlet/switch and
1-pole inlet/fuseholder
Other dimensions for
2-pole modules:
d1 = 6 ± 0.05 (snap-in)
d1 = 3.6 (screw-on)
d2 = 2 ± 0.1 (screw-on)
Tolerances not marked:
≤ 15 = ± 0.05
≥ 15 = ± 0.1
Ground Terminal
0 = protection class II, without ground
1* = protection class I, solder/quick-connect
4.8 x 0.8mm, in connector axis
2 = protection class I, solder/quick-connect
6.3 x 0.8mm, in connector axis
6 = protection class I, solder/quick-connect
4.8 x 0.8mm, 90˚ to connector axis
7 = protection class I, solder/quick-connect
6.3 x 0.8mm, 90˚ to connector axis
KP01. 1 X X X . X X
Line switch
0 = without switch
non-illuminated illuminated 100- 250V~
1* = black 7*= red
2 = white 8*= green
3 = red 9 = orange
4 = green
5 = orange
Mounting
For snap-in Pcb mount (thickness 1.6 mm):
11 = slot for panel, thickness S = 1.0mm
12*= slot for panel, thickness S = 1.5 – 2.0mm
13*= slot for panel, thickness S = 2.5 – 3.0mm
14 = slot for panel, thickness S = 3.5 – 4.0mm
15 = without slot for panel fixation
For screw-on Pcb mount (thickness 1.2-2.5mm):
With or without self-tapping screws, ø3 x 8mm
With Without
51 61 panel thickness S = 1.0mm
52* 62 panel thickness S = 1.5 – 2.0mm
53* 63 panel thickness S = 2.5 – 3.0mm
54 64 panel thickness S = 3.5 – 4.0mm
55 65 panel thickness S = 0
Standard combinations
0 = AC inlet with ac outlet
1 = AC inlet with on/off line switch, 2-pole
2 = AC inlet with on/off line switch, 1-pole
3 = AC inlet with fuseholder, 2-pole
4 = AC inlet with fuseholder, 1-pole
* standard configuration. Contact Schurter for non-standard order minimums.
Color of Housing
1* = black
Basic Specification
KP01 = Power entry module for Pcb mounting,
SNAP
FIT
or SCREW
FIT
Prtotection class I, solder/quick-connect ground
terminal 4.8 x 0.8mm in connector axis
Black unlighted rocker switch
Snap-in pcb mounting (1.6mm pcb), with bezel for
1.5-2.0mm panel
Combination ac inlet with on/off line switch (2-pole)
Black housing
Power entry module for pcb mounting
Ordering example:
KP01.1112.11