MAX. No. of PSUs on 16A
CIRCUIT BREAKER 9 units (circuit breaker of type B) / 15 units (circuit breaker of type C) at 230VAC
SPECIFICATION
MODEL APC-25-350 APC-25-700
DC VOLTAGE RANGE
RATED CURRENT
RATED POWER
OUTPUT
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
VOLTAGE RANGE Note.4
FREQUENCY RANGE
EFFICIENCY(Typ.)
AC CURRENT
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVER VOLTAGE
25~70V 11~36V
350mA 700mA
24.5W 25.2W
300mVp-p 300mVp-p
±5.0%
±1.0%
±3.0%
1500ms, 30ms / 230VAC 1500ms, 30ms / 115VAC at full load
47 ~ 63Hz
83% 83%
0.4A/230VAC;0.8A/115VAC
0.25mA / 240VAC
20 ~ 90% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH℃
±℃ ℃0.2%/ (0 ~ 50 )
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.℃
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristic for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6.The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
25W Single Output Switching Power Supply
Constant current mode power supply
Universal AC input / Full range
Withstand 300VAC Surge input for 5 seconds
Protections:Short circuit / Over voltage
Fully isolated plastic case
Small and compact size
Cooling by free air convection
IP30 design
100% full load burn-in test
Suitable for LED lighting and moving sign applications
Low cost / High reliability
2 years warranty
RIPPLE & NOISE (max.) Note.2
VOLTAGE TOLERANCE Note.3
ENVIRONMENT
SAFETY &
EMC
(Note 5)
PROTECTION
File Name: APC-25-SPEC 2015-05-28
SAFETY STANDARDS
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
I/P-O/P:3KVAC
HOLD UP TIME (Typ.) 20ms/230VAC 12ms/115VAC at full load
76 ~ 94V 41 ~ 49V
84*57*29.5(L*W*H)
COLD START 45A(twidth=310 s measured at 50% Ipeak) at 230VACμ
UL8750 (except for APC-25-350), CSA-C22.2 No. 250.0-13 (only for APC-25-700&1050) approved; design refer to EN60950-1
518.9K hrs min. MIL-HDBK-217F (25 )℃
■Features :
LPS (except for APC-25-350)
I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH℃
90 ~ 264VAC 127 ~ 370VDC
APC-25 series
CURRENT ACCURACY
±8.0%
EMC IMMUNITY
Compliance to EN55022,EN61000-3-2 Class A,EN61000-3-3
Compliance to EN55024,EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV), criteria A
EMC EMISSION
APC-25-500
15~50V
500mA
25.2W
300mVp-p
83%
55 ~ 68V
APC-25-1050
9~24V
1050mA
25.2W
300mVp-p
83%
27 ~ 35V
-30 ~ 70 (Refer to "Derating Curve")℃
0.13Kg; 72pcs/10.4Kg/0.92CUFT
Protection type : Shut down o/p voltage, re-power on to recover
(only for APC-25-700&1050)
( only for APC-25-500)
Mechanical Specification
Derating Curve Static Characteristics
AMBIENT TEMPERATURE ( )℃
LOAD (%)
(HORIZONTAL)
Block Diagram
DETECTION
PWM
CIRCUIT
EMI FILTER
POWER
SWITCH-
FILTER
&
RECTIFIERS +V
-V
I/P
ING
CONTROL
25W Single Output Switching Power Supply APC-25 series
INPUT VOLTAGE (VAC) 60Hz
90 100 200 220
210 230 250
240 264
LOAD (%)
90
100
80
70
60
50
40
fosc : 60KHz
RECTIFIERS
File Name: APC-25-SPEC 2015-05-28
Case No.PCD16A Unit:mm
29.5
1.9
57
15.3
15.3
2- 3.6ψ
2- 8.9ψ
84
UL1569 18AWG
UL1569 18AWG V+(RED)
V-(BLACK)
AC/N(Blue)
AC/L(Brown)
3
3
150 10±
150 10±
7.3
7.3
5
Tcase
5
※T case: Max. Case Temperature.
-30 0 10 20 30 40 50 70
20
40
60
80
100
50
60
