NJM2149
- 2 -
■
■■
■ ABSOLUTE MAXMUM RANGE (Ta=25°C)
PARAMETER SYMBOL RATINGS UNIT
Supply Vo ltage V+ +7 V
Power Dis si p ati on PD
(DIP8) 500
(DMP8) 500 (note1)
(SSOP8) 360 (note1)
(VSP8/TVSP8) 320
mW
Operating Te mper at ure Range Topr -40 to +85 °C
Storage Te mper at ure R ange Tstg -40 to +125 °C
(note1)Mounted on PC Boar d
■
■■
■ ELE CTRI CAL CHA RACT E RIS TI CS (V
+=6.0V, 1pin=2V, Ta=25°C u nless otherwise sp ecified)
PARAMETER SYMBOL TEST CONDITIONS MIN. TYP. MAX. UNIT
Operatin g Voltage V+ 2.0 - 6.0 V
Operating Current ICC V+=3.0V, RL=∞, No Signa l - 2.2 3.5 mA
Operating Current
at Power Down Mode ICCD V+=3.0V, RL=∞, 1pi n= 0.8V, No Signal - 0.1 1.0
µA
Open Loop G ain AV1 Amp#A, f<100Hz 84 90 - dB
Closed Loop Gain AV2 Amp#B, f=1kHz, RL=32Ω -0.35 0 +0.35 dB
Output Power PO1 V+=3.0V, RL=16Ω, THD≤10% (note2) 55 - - mW
P
O2 V+=6.0V, RL=32Ω, THD≤10% (note2) 250 - - mW
Tot al Har moni c
Distortion THD1 V+=6V, RL=32Ω, PO=125mW,
f =1kHz, GVD=34dB - 0.5 1.0 %
THD2
V+≥3V, RL=8Ω, PO=20mW,
f=1 k Hz, G VD=12dB - 0.5 - %
Power S upply SVR1 C1=∞, C2=0.01µF, DC 50 - - dB
Rejection Ratio SVR2 C1=0.1µF, C2=0, f=1kHz - 12 - dB
(V+=3.0V-6.0V) SVR3
C1=1.0µF, C2=5.0µF, f=1kHz - 47 - dB
Mute Attenuation MAT f =1kHz- 20kHz, 1pin=0. 8V - 70 - dB
Output Voltage VO1 V+=3.0V, RL=16Ω 1.00 1.15 1.25 V
(Rf=75kΩ, DC) VO2 V+=6.0V - 2.60 - V
Output Hi gh Level VOH IOUT=-75mA, V+=2.0-6.0V - V+-1.1 - V
Output Low Level VOL IOUT=75mA, V+=2.0-6.0V -30 0.21 - V
Output DC Offset ∆VO Rf=75kΩ, RL=32Ω, 5pin-8pin -30 0 +30 mV
Input Bias C urrent IB 4pin - 0 -200 nA
Equiva lent Resistance R+IN 3pin 100 170 220 kΩ
R
REF 2pin 18 26 40
kΩ
CD Input Voltage H VCDH 1pin 2.0 - V+ V
CD Input Volt age L VCDL 1pin 0.0 - 0.8 V
CD Input Resi stance RCD V+=VCD=6.0V, 1pin 50 85 175 kΩ
(note2) NJM2149M,NJM2149V,NJM21 49R,NJM214 9R B1:Mounted on PC Bo ard
■
■■
■ CONT RO L TE R MINAL EXPLANATIO N
CHIP DI SA BL E CON TRO L( C D PIN)
PARAMETER CONTROL SIGNAL STATUS
CD OFF H(=VCDH) IC is active.
CD ON L(=VCDL) IC is standby. (with Mute)