Memory Module Specifications KVR16R11S8K2/8 8GB (4GB 1Rx8 512M x 72-Bit x 2 pcs.) PC3-12800 CL11 Registered w/Parity 240-Pin DIMM Kit DESCRIPTION SPECIFICATIONS ValueRAM's KVR16R11S8K2/8 is a kit of two 512M x 72-bit CL(IDD) 11 cycles (4GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM), regis- Row Cycle Time (tRCmin) 48.125ns (min.) tered w/parity, 1Rx8 ECC, memory modules, based on nine Refresh to Active/Refresh Command Time (tRFCmin) 260ns (min.) 512M x 8-bit FBGA components per module. Total kit capacity is 8GB. The SPDs are programmed to JEDEC standard latency Row Active Time (tRASmin) 35ns (min.) DDR3-1600 timing of 11-11-11 at 1.5V. Each 240-pin DIMM Maximum Operating Power 2.814 W* (per module) uses gold contact fingers. The electrical and mechanical specifications are as follows: FEATURES * JEDEC standard 1.5V (1.425V ~1.575V) Power Supply * VDDQ = 1.5V (1.425V ~ 1.575V) * 800MHz fCK for 1600Mb/sec/pin * 8 independent internal bank * Programmable CAS Latency: 11, 10, 9, 8, 7, 6 * Programmable Additive Latency: 0, CL - 2, or CL - 1 clock * 8-bit pre-fetch * Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] * Bi-directional Differential Data Strobe * Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm 1%) * On Die Termination using ODT pin * On-DIMM thermal sensor (Grade B) * Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C * Asynchronous Reset * PCB : Height 1.180" (30.00mm), double sided component UL Rating 94 V - 0 Operating Temperature 0o C to 85o C Storage Temperature -55o C to +100o C *Power will vary depending on the SDRAM and Register/PLL used. Continued >> Document No. VALUERAM1378-001.A00 11/20/13 Page 1 MODULE DIMENSIONS: (units = millimeters) Document No. VALUERAM1378-001.A00 Page 2