RoHS Compliant Low Noise GaAs MMIC Amplifier 1.2 - 1.75 GHz Features * * * * * * MAAM12000-A1 V4 Schematic Low Noise Figure: 1.35 dB High Gain: 26 dB No External Components Required DC Decoupled RF Input and Output Lead-Free 8-Lead Ceramic Package RoHS* Compliant and 260C Reflow Compatible Typical Biasing Configuration and Functional Block Diagram GND GND RF IN Description M/A-COM's MAAM12000-A1 is a wide band, low noise, MMIC amplifier housed in a lead-free, small 8-lead ceramic package. It includes two integrated gain stages and employs series inductive feedback to obtain excellent noise figure and a good, 50-ohm, input and output impedance match over the 1.2 to 1.75 GHz band. The MAAM12000-A1 is fully monolithic, requires no external components and is provided in a low-cost, user-friendly, microwave package. The MAAM12000-A1 is ideally suited to receivers in GPS and DGPS applications and operates over both the L1 and L2 frequency bands. Because of its wide bandwidth, the MAAM12000-A1 can also be used as a driver, buffer or IF amplifier in numerous commercial and government system applications that require high gain, excellent linearity and low power consumption. GND GND VGG VDD Pin Configuration1 Pin No. Function Pin No. Function 1 Ground 5 VDD 2 RF Input 6 Ground 3 Ground 7 RF Output 4 VGG 8 Ground 1. The package bottom must be connected to RF and DC ground. Absolute Maximum Ratings 2,3 The MAAM12000-A1 is manufactured in-house using a reliable, 0.5 micron, GaAs MESFET process. This product is 100% RF tested to ensure compliance to performance specifications. Ordering Information RF OUT Parameter Absolute Maximum VDD +7 V VGG -10 V Input Power +20 dBm Current 150 mA Channel Temperature Part Number Package MAAM12000-A1 8-Lead Ceramic MAAM12000-A1G Gull Wing Operating Temperature Storage Temperature +150C 4 -55C to +100C -65C to +150C 2. Exceeding any one or combination of these limits may cause permanent damage to this device. 3. M/A-COM does not recommend sustained operation near these survivability limits. 4. Typical thermal resistance (jc) = +110C/W. * Restrictions on Hazardous Substances, European Union Directive 2002/95/EC. 1 M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information. * North America Tel: 800.366.2266 / Fax: 978.366.2266 * Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 * Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information. RoHS Compliant Low Noise GaAs MMIC Amplifier 1.2 - 1.75 GHz MAAM12000-A1 V4 Electrical Specifications: TA = 25C, VDD = +5 V, VGG = -5 V, Z0 = 50 Parameter Test Conditions Units Min. Typ. Max. Gain 1.20 - 1.75 GHz, PIN = -30 dBm dB 23 26 -- Noise Figure 1.20 - 1.75 GHz, PIN = -30 dBm dB -- 1.35 1.8 Input VSWR 1.20 - 1.75 GHz, PIN = -30 dBm Ratio -- 1.4:1 -- Output VSWR 1.20 - 1.75 GHz, PIN = -30 dBm Ratio -- 1.4:1 -- Output 1 dB Compression 1.20 - 1.75 GHz dBm -- +14 -- Input IP3 1.20 - 1.75 GHz, PIN = -30 dBm dBm -- -2 -- Reverse Isolation 1.20 - 1.75 GHz, PIN = -30 dBm dB -- 35 -- Bias Current -- mA -- 80 110 Lead-Free CR-3 (MAAM12000-A1) Handling Procedures Please observe the following precautions to avoid damage: Static Sensitivity Gallium Arsenide Integrated Circuits are sensitive to electrostatic discharge (ESD) and can be damaged by static electricity. Proper ESD control techniques should be used when handling these devices. Operating The MAAM12000-A1 Nominal bias is obtained by connecting -5 volts to pin 4 (VGG) followed by connecting +5 volts to pin 5 (VDD). Note sequence. Lead-Free CR-10 (MAAM12000-A1G) Power down in reverse sequence. 2 M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information. Reference Application Note M538 for lead-free solder reflow recommendations. * North America Tel: 800.366.2266 / Fax: 978.366.2266 * Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 * Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information. RoHS Compliant Low Noise GaAs MMIC Amplifier 1.2 - 1.75 GHz MAAM12000-A1 V4 Typical Performance Curves VSWR Gain 3.0 30 Input Output 25 2.5 20 2.0 15 10 1.5 5 0 0.8 1.0 1.2 1.4 1.6 1.8 2.0 2.2 1.0 0.8 1.0 1.2 1.4 1.6 1.8 2.0 2.2 2.0 2.2 Frequency (GHz) Frequency (GHz) Reverse Isolation Noise Figure 2.5 0 -10 2.0 -20 1.5 -30 -40 1.0 -50 0.5 -60 0.0 0.8 1.0 1.2 1.4 1.6 1.8 2.0 2.2 -70 0.8 1.0 1.2 1.4 1.6 1.8 Frequency (GHz) Frequency (GHz) Output Power 24 20 16 12 8 4 0 0.8 1.0 1.2 1.4 1.6 1.8 2.0 2.2 Frequency (GHz) 3 M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information. * North America Tel: 800.366.2266 / Fax: 978.366.2266 * Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 * Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information.