4
Radial Lead Type 1F – 50F
MECHANICAL SPECIFICATIONS
Radial Bent Lead Type
SOLDERING RECOMMENDATIONS
When soldering SuperCapacitors to a PCB, the temperature &
time that the body of the SuperCapacitor sees during soldering
can have a negative eect on performance. We advise following
these guidelines:
• Do not immerse the SuperCapacitors in solder. Only the leads
should come in contact with the solder.
• Ensure that the body of the SuperCapacitor is never in contact
with the molten solder, the PCB or other components during
soldering.
• Excessive temperatures or excessive temperature cycling
during soldering may cause the safety vent to burst or the
case to shrink or crack, potentially damaging the PCB or other
components, and signicantly reduce the life of the capacitor.
HAND SOLDERING
Keep distance between the SuperCapacitor body and the tip of
the soldering iron and the tip should never touch the body of the
capacitor. Contact between SuperCapacitor body and soldering
iron will cause extensive damage to the SuperCapacitor, and
change its electrical properties. It is recommended that the
soldering iron temperature should be less than 350°C, and
contact time should be limited to less than 4 seconds. Too much
exposure to terminal heat during soldering can cause heat to
transfer to the body of the SuperCapacitor, potentially damaging
the electrical properties of the SuperCapacitor.
WAVE SOLDERING
Only use wave soldering on Radial type SuperCapacitors. The
PCB should be preheated only from the bottom and for less than
60 seconds, with temperature at, or below, 100°C on the top side
of the board for PCBs equal to or greater than 0.8 mm thick.
REFLOW SOLDERING
Infrared or conveyor over reow techniques can be used on
these SuperCapacitors. Do not use a traditional reow oven
without clear rated reow temperature for SuperCapacitors.
042219
Style B (mm)
A1 4
C1 2
Solder Temperature
(ºC)
Suggested Solder
Time (s)
Maximum Solder
Time (s)
220 7 9
240 7 9
250 5 7
260 3 5
3.0V SCC Series
High Capacitance Cylindrical SuperCapacitors
D
(mm)
P
(mm)
d
(mm)
6.3 2.3 0.6
8 3.5 0.6
10 5.0 0.6
12.5 5.5 0.6
16 7.5 0.8
18 8.0 0.8