Date: 10-09-06 EPS120050-P7P Switching Power Supply AC/DC Direct Plug in Adapter Page No: 1 / 3 Features * Energy Star and California Energy Commission Regulations compliant * RoHS Compliant * 100-120 VAC input * Regulated output voltage * Over-load protected * Short-circuit protected * UL/cUL certified and FCC class B compliant * Designed to replace linear AC-DC adapters which are unable to meet CEC manditory efficiency requirements Models Model EPS120050-P7P Output Voltage 12.0 V Output Current Minimum Maximum 0A 500 mA Max. Power 6.0 W Ripple & Noise (mVpp)1 120 Notes: 1. Ripple & Noise measured at 20 MHz BW, with a 0.1 F ceramic cap and a 10 F electrolytic cap on the output. Input Parameter Input frequency Input voltage Inrush current Power dissipation Phone: 800.275.4899 Conditions/Description Min 47 100 Peak measured at 120 VAC. Inrush lasts no more than 0.5mS before settling to steady state current. Input: 100~120VAC; Output: no load Fax: 503.612.2381 www.cui.com Nom 120 Max 63 130 40 Units Hz VAC A 0.5 W 20050 SW 112th Ave. Tualatin, OR 97062 Date: 10-09-06 EPS120050-P7P Switching Power Supply AC/DC Direct Plug in Adapter Page No: 2 / 3 Output Parameter Line regulation Load regulation Overshoot Undershoot Temp. coefficient Start-up time Hold-up time Output Connector Output power limit Conditions/Description Low line to high line at full load Full load to no load At turn-on and turn-off At turn-on and turn-off 0 to 40C, full load, after initial 1 hour warm up Time needed to reach regulation @ 115 Vac, Full load Center positive Primary power limited Min -2 -5 Nom Max +2 +5 0 0 -0.02 +0.02 3 10 Units % % % % %/C S mS Protection Circuit Parameter Overload Short circuit Conditions/Description Fold-back current limiting starts at 105-160% of the rated output current. Recovers automatically. Long term exposure to overloaded condition may reduce product reliability. Short circuit can be continuous. Recovers automatically upon removal of short. General and Safety Parameter Efficiency Operating temp. Storage temp. Operating humid. Storage humid. Leakage current Isolation voltage (HI-POT) MTBF Dimensions Weight Material flamm. EMI RoHS compliant Safety Conditions/Description Energy star level-IV Min Non-condensing Non-condensing at 120 VAC Applied for 1 minute Input to output: Per MIL-HDBK-217E @ 25C 43.3 x 63.0 x 26.6 for case only Nom 0 -20 10% 10% Max Units 40 85 90% 90% 0.5 C C RH RH mA 3000 240,000 90 3.2 UL94V-0 Conducted emissions Radiated emissions Yes UL/cUL1310 V rms Hours mm g oz. FCC part 15, class B FCC part 15, class B *CUI Inc. reserves the right to make changes to its products or to discontinue any product or service without notice, and to advise customers to verify the most up-to-date product information before placing orders. CUI Inc. assumes no liability or responsibility for customer's applications using CUI Inc. products other than repair or replacing (at CUI's option) CUI Inc. products not meeting CUI's published specifications. Nothing will be covered outside of standard product warranty. Phone: 800.275.4899 Fax: 503.612.2381 www.cui.com 20050 SW 112th Ave. Tualatin, OR 97062 Phone: 800.275.4899 Fax: 503.612.2381 www.cui.com COPYRIGHT 2006 BY CUI INC. 1800 100 43.3 1.0 63 1.0 26.6 1.0 B 3.50 DETAIL B SCALE 3 : 2 1.35 9.5 NOTE 1: THIS POWER UNIT IS INTENDED TO BE CORRECTLY ORIENTED IN A VERTICAL OR FLOOR MOUNT POSITION. 22.3X18.0 20050 SW 112th Ave. ZRJ DRAWN BY: EPS-P7 EPS06 Series PART NO. TITLE: Tolerance: X.X 0.5mm X.XX 0.03mm APPROVED BY: UNITS: 20050 SW 112th Ave. Tualatin, OR 97062 Phone: 503-643-4899 800-275-4899 Fax: 503-372-1266 Website: www.cui.com ESCRIPTION NEW DRAWING Units: mm D A 2:1 SCALE: MM [INCHES] REV: RoHS DATE 10/3/2006 AC/DC Direct Plug in Adapter Base-P7 PC FILE NAME : 3.0 (TYP) 6.3 12.7 17.0 REV. A EPS120050-P7P Switching Power Supply Date: 10-09-06 Page No: 3 / 3 Tualatin, OR 97062