HARTING Ha-VIS eCon Switches
Energy
Efficient
Ethernet
Voltage supply
Nominal voltage 48 VDC 54 VDC
Permissible voltage range
44 VDC ... 57 VDC
50 VDC ... 57 VDC
Surge protection Yes
Reverse polarity proof Yes
Starting current 6.40 A 7.20 A
Overcurrent protection at input Yes (12 A)
Max. power consumption without PoE 3,84 W ... 4.56 W
Cross-section / Wire gauge 0.08 mm² ... 2.5 mm² (28 AWG ... 12 AWG)
Connection type 3-pole, pluggable screwed contact
Pinout + / - /
Supply circuit (acc. to 60950) SELV (circuit breaker 10 A)
Ha-VIS eCon 3000
Full Gigabit Ethernet
Basic PoE / PoE+
General description
The Ha-VIS eCon 3000 Full Gigabit family of unmanaged Ethernet switches
is equipped with up to 7 gigabit Ethernet ports and allow for cost-efficient
and quick expansion and/or reconstruction of network infrastructures
with high bandwidth requirements. In this, all switches support extra-long
Ethernet frames (jumbo frames). The switches work as power sourcing
equipment (PSE) and are capable of simultaneously providing the full PoE
output of 34.2 watts on up to four ports. The slender design of the switches
enables an extremely high packing density on the DIN rail. Various
combinations of variants with RJ45, fibre optic cables and SFP ports are
available. Automatic detection of the transmission rate (auto-negotiation)
and of the wiring of the twisted pair data cable (autopolarity and auto-
MDI(X)) allow for simple plug & play. All variants are available with the
temperature ranges „Industrial“ and „Commercial“.
Target markets
Machinery &
Robotics Automation technology Industrial network
infrastructures
Wind Energy
Solar Energy Transportation Shipbuilding
■ Energy supply of up to 4 terminal devices via PoE+ (137 watts)
acc. to IEEE 802.3at
■ Full gigabit Ethernet, non-blocking switch architecture acc. to IEEE 802.3
■Support of jumbo frames
■Variants with industrial temperature range of -40°C ... +70 °C
■Surge protection and reverse polarity protection
■Minimum energy consumption due to Energy-Efficient Ethernet
■Optimised DIN rail bracket
5 to 7 Ethernet ports RJ45, SC/LC (SFP) and PoE / PoE+
Unmanaged Plug & Play Ethernet switches for DIN rail assembly in control
cabinets
Commercial Temp.: 0 °C ... +55 °C / Industrial Temp.: -40 °C ... +70 °C
Switch Features
Enclosures width 25 mm
Number of ports 5, 6, 7
Switching technology Store and Forward
Supported standards IEEE 802.3
Frame Size 10 kbytes
MAC table size 8k entries
Packet buffer size 1 Mbit
Non-blocking Yes
Quality of service Yes
Energy-Efficient Ethernet Yes
PROFINET compatible Yes
EthernetIP compatible Yes
Ethernet Ports 10BASE-Te / 100BASE-TX EEE / 1000BASE-T EEE
Connection type RJ45
Auto-negotiation Yes
Auto-polarity Yes
Auto-MDI(X) Yes
Transfer conditions Twisted Pair
Transfer speed 10 / 100 / 1000 Mbit/s
Transfer length 100 m (twisted pair, Cat 5)
Ethernet Ports 1000BASE-SX / 1000BASE-LX
Type of fibre Multimode (MM) Singlemode (SM)
Connection type SC Duplex
Transfer conditions FO
Wavelength 850 nm 1310 nm
Transfer speed 1000 Mbit/s
Transfer length 0.55 km 10 km
Output power -9.5 dBm ... -3 dBm -9.5 dBm ... -4 dBm
Input sensitivity ≤ -17 dBm ≤ -21 dBm
SFP ports
Transfer standard Depending on used SFP
Connection type Depending on used SFP, RJ45 or LC
Transfer conditions Depending on used SFP, TP or FO
Transfer speed Depending on used SFP, 100 or 1000 Mbit/s
Transfer length Depending on used SFP
Technical characteristics
HARTING Technology Group
P.O.Box 1473, D-32325 Espelkamp
Wilhelm-Harting-Straße 1, D-32325 Espelkamp, Germany
ICPN-Service@harting.com | Service hotline: +49 5772 47-9479
Fax: +49 5772 47-495 | www.HARTING.com/de/ethernet-switches
Note: We reserve the right to make technical changes to the products and to the content of this
document at any time without prior notication. The HARTING Technologiegruppe does not accept
any responsibility for possible errors or incompletions in this document. We reserve all the rights to
this document and the topics and illustrations contained within it. Copying, disclosure to third parties
or use of its content - even partially - is forbidden without the prior written consent of the HARTING
Technologiegruppe.
Status and diagnostic displays
Power („Pwr“) lights up green Supply voltage is applied
Link/Activity („L/A“) off No link
Link/Activity („L/A“) lights up green Link is active
Link/Activity („L/A“) flashes green Link is active and data is transferred
Link speed („Spd“) off 10 Mbit/s
Link speed („Spd“) lights up yellow 100 Mbit/s
Link speed („Spd“) lights up green 1000 Mbit/s
PoE status off PoE is inactive / low voltage
PoE status lights up green Voltage in PoE range
PoE status lights up blue Voltage in PoE+ range
PoE status lights up red Error
PoE PoE PoE+
Number of PoE ports 4
Standard IEEE 802.3af / IEEE 802.3at
PoE type PSE
Supported mode Alternative A
Supply voltage PSE 48 VDC 54 VDC
Max. current consumption PSE
1380 mA 2380 mA
Max. current 375 mA 638 mA
Maximum output power PSE 15.4 W per port
61.6 W total
34.2 W per port
136.8 W total
Supported cabling See 802.3at, section 33.1.4
PoE pinout Alternative A, MDI-X (1/2 = V-, 3/6 = V+)
Ambient conditions
Commercial temperature range 0 °C ... +55 °C
Industrial temperature range -40 °C ... +70 °C
Storage temperature range -40 °C ... +85 °C
Relative humidity (operation) 0 % ... 95 % (not-condensing)
Relative humidity
(storage and transport) 0 % ... 95 % (not-condensing)
Air pressure (operation) 2000 m (795 hPa)
Drawings
Enclosures
Enclosures width 25 mm
Dimensions H x W x D
(without pluggable screw con-
tact and holding bracket)
142 mm x 25 mm x 107.5 mm
Weight 498 g ... 531 g
Type of installation 35 mm DIN rail acc. to EN 60 715
Material enclosures Anodised aluminium / Powder-coated
steel sheet
Protection degree (withplugged
screw contact) IP30
Protection class III
Approvals
CE, FCC CFR 47 Part 15, cUL US 508 listed, DNV GL, LR, NK, ABB IIT
EMC and environmental conditions
EMC Interference immunity (EN 61000-6-1, 61 000-6-2 55024)
Electrostatic discharge (ESD) EN 61 000-4-2
Electromagnetic field EN 61 000-4-3
Rapid transients (burst) EN 61 000-4-4
Surge voltages EN 61 000-4-5
Conducted interference voltages EN 61 000-4-6
EMC Interference emission (EN 61000-6-4, EN 55 032,
FCC CFR 47 Part 15)
Mechanical stability (EN 60721-3)
IEC 60068-2-6 Vibration
IEC 60068-2-6 Vibration resonance search
IEC 60068-2-27 Shock test
Included in delivery
■Pluggable screw contact for voltage supply
■ Assembly instruction
Ports / order information
Current
consumption
@ 54 VDC
with PoE
Commercial Temp.: 0 °C ... +55 °C Industrial Temp.: -40 °C ... +70 °C
RJ45 SFP SC Enclosures
width
MTBF
in Mio. h Switch Part no. Switch Part no.
4 - 1x MM (0.55 km) 25 mm 2.42 A 1.13 Ha-VIS eCon 3041GB-AD-P 24 03 404 1130 Ha-VIS eCon 3041GBT-AD-P 24 03 404 1120
4 - 1x SM (10 km) 25 mm 2.42 A 1.13 Ha-VIS eCon 3041GB-AF-P 24 03 404 1230 Ha-VIS eCon 3041GBT-AF-P 24 03 404 1220
4 - 2x MM (0.55 km) 25 mm 2.44 A 1.11 Ha-VIS eCon 3042GB-AD-P 24 03 404 2130 Ha-VIS eCon 3042GBT-AD-P 24 03 404 2120
4 - 2x SM (10 km) 25 mm 2.44 A 1.11 Ha-VIS eCon 3042GB-AF-P 24 03 404 2230 Ha-VIS eCon 3042GBT-AF-P 24 03 404 2220
4 3 - 25 mm 2.44 A 0.70 Ha-VIS eCon 3043GB-AC-P 24 03 404 3330 Ha-VIS eCon 3043GBT-AC-P 24 03 404 3320
5 - - 25 mm 2.42 A 1.08 Ha-VIS eCon 3050GB-A-P 24 03 405 0030 Ha-VIS eCon 3050GBT-A-P 24 03 405 0020
5 - 1x MM (0.55 km) 25 mm 2.44 A 1.06 Ha-VIS eCon 3051GB-AD-P 24 03 405 1130 Ha-VIS eCon 3051GBT-AD-P 24 03 405 1120
5 - 1x SM (10 km) 25 mm 2.44 A 1.06 Ha-VIS eCon 3051GB-AF-P 24 03 405 1230 Ha-VIS eCon 3051GBT-AF-P 24 03 405 1220
5 2 - 25 mm 2.45 A 0.68 Ha-VIS eCon 3052GB-AC-P 24 03 405 2330 Ha-VIS eCon 3052GBT-AC-P 24 03 405 2320
6 - - 25 mm 2.43 A 1.01 Ha-VIS eCon 3060GB-A-P 24 03 406 0030 Ha-VIS eCon 3060GBT-A-P 24 03 406 0020
6 1 - 25 mm 2.45 A 0.66 Ha-VIS eCon 3061GB-AC-P 24 03 406 1330 Ha-VIS eCon 3061GBT-AC-P 24 03 406 1320
7 - - 25 mm 2.45 A 0.63 Ha-VIS eCon 3070GB-A-P 24 03 407 0030 Ha-VIS eCon 3070GBT-A-P 24 03 407 0020
Technical characteristics / order information
Copyright© 2014
HARTING Technology Group
All rights reserved
Date of issue 06.2018
ICPN Datasheet 0850/02
