P17E14.pdf 04.8.24 !Note Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc. This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specificaions before ordering. 1 Characteristics and Types of CERALOCK(R) MHz Band CERALOCK(R) (CSALS Series) Because CSALS Series uses the thickness vibration mode of piezoelectric ceramic element, there is little difference of dimensions over the whole frequency band. !Part Numbers and Dimensions of MHz Band CERALOCK(R) (CSALS Series) Part Number Frequency (MHz) Dimensions (in mm) 5.5 X 16.00-70.00 3.5 CSALS 6.5 3.0 1 !Part Numbering 5.00.3 (Ex.) CS A LS 33M8 X 5 1 q w e r t y u -B0 i o qProduct ID wFrequency/No capacitance built-in eStructure/Size LS : Round Lead Type rNominal Center Frequency tType X : Thickness Longitudinal Vibration (3rd overtone) yFrequency Tolerance 2 : 0.2%, 3 : 0.3%, 5 : 0.5%, Z : Others uLoad Capacitance Value iIndividual Specification With standard products, "i individual Specification" is omitted, and "o Package Specification Code" is carried up. oPackaging -B0 : Bulk, -A0 : Radial Taping H0=18mm Ammo Pack (Standard) 4 16.00-32.99MHz : 3.5 !Note Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc. This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specificaions before ordering. P17E14.pdf 04.8.24 Characteristics and Types of CERALOCK(R) 1 !Specifications of Taped Products of MHz Band CERALOCK(R) (CSALS Series) P P2 dh dh 1 dS H0 W0 L1 W W1 d H1 W2 A D D0 P1 F P0 Item Code Dimensions Tolerance D 5.5 Height of resonator A 6.5 0.5 Dimensions of terminal d o0.48 0.05 Lead length under the hold down tape L1 5.0 min. ------ Pitch of component P 12.7 0.5 Pitch of sprocket hole P0 12.7 0.2 Length from sprocket hole center to lead P1 3.85 0.5 Length from sprocket hole center to component center P2 6.35 0.5 Lead spacing F 5.0 0.3 Slant to the forward or backward dh 0 1.0 Width of carrier tape W 18.0 0.5 Width of hold down tape W0 6.0 min. ------ Position of sprocket hole W1 9.0 Gap of hold down tape and carrier tape W2 0 0.5 +0.5 -0 Distance between the center of sprocket hole and lead stopper H0 18.0 0.5 Total height of resonator H1 24.5 1.0 Diameter of sprocket hole D0 o4.0 0.2 0.6 0.2 0 1.0 Body tilt * CSTLS series is also available on tape. t dS Remarks 1.0 Width of diameter Total tape thickness t Direction of Feed Tolerance for Pitches 10xP0=1271 1mm max. Hold down tape doesn't exceed the carrier tape. (in mm) 5