15 Watt XC Single Series DC/DC Converters
Manufacturing Company, Inc.
• Concord, California 94520 • Ph: 925/687-4411 or 800/542-3355 • Fax: 925/687-3333 • www.calex.com • Email: sales@calex.com
2eco# 041007-1
NOTES
*All Parameters measured at Tc=25°C, nominal input voltage
and full rated load unless otherwise noted. Refer to the
CALEX Application Notes for the definition of terms,
measurement circuits and other information.
(2) Determine the correct fuse size by calculating the maximum DC
current drain at low line input, maximum load then adding 20 to
25 percent. Slow blow type recommended.
(3) No minimum load required.
(4) Short term stability is specified after a 30 minute warm-up at full
load, and with constant line, load and ambient conditions.
(5) The transient response is specified as the time required to settle
from 50 to 75% step load change (rise time of step = 2µSec.) to
a 1% error band.
(6) Dynamic response is the peak overshoot voltage during the
transient response time defined in note 5 above.
(7) The input ripple rejection is specified for DC to 120Hz ripple with
a modulation amplitude of 1% Vin.
(8) For module protection only, also see note 2.
(9) The logic shutdown pin is Open Collector TTL, CMOS, and relay
compatible. The input to this pin is referenced to input minus and
is protected to +100VDC.
(10) The functional temperature range is intended to give an additional
data point for use in evaluating this power supply. At the low
functional temperature the power supply will function with no
side effects, however, sustained operation at the high functional
temperature will reduce expected operational life. The data
sheet specifications are not guaranteed over the functional
temperature range.
(11) The case thermal impedance is specified as the case temperature
rise over ambient per package watt dissipated.
(12) Water Washability - Calex DC/DC converters are designed to
withstand most solder/wash processes. Careful attention should
be used when assessing the applicability in your specific
manufacturing process. Converters are not hermetically sealed.
*sretemaraPtupnI
ledoMCX0003.5S21CX0521.21S21CX0001.51S21CX0003.5S84CX0521.21S84CX0001.51S84stinU
egnaRegatloV NIM XAM 0.9 0.72 0.4
20.27 CDV
,elppiRdetcelfeR wbzHM02-0 PYT XAM 001 002 05 001 P-PAm
daoLlluFtnerruCtupnI daoLoN PYT PYT 0061 02 0451 03 0251 03 593 51 093 02 083 02 Am
ycneiciffEPYT9871828970828%
ycneuqerFgnihctiwSPYT07zHk
tupnImumixaM ,egatlovrevO egamaDoNsm001 X
AM2358CDV
tuokcoLegatlovrednU5.871CDV
,emiTno-nruT rorrEtuptuO%1 PYT51sm
esuFdednemmoceR )2(
*sretemaraPtuptuO
ledoM CX0003.5S21 CX0003.5S84 CX0521.21S21 CX0521.21S84 CX0001.51S21 CX0001.51S84 stinU
egatloVtuptuO52151CDV
)3(t
nerruCdetaR NIM XAM 00003 00521 00001 Am
egnaRegatloV daoL%001
NIM PYT XAM
59.4 00.5 50.5
09.11 00.21 01.21
09.41 00.51 0
1.51 CDV
daoL%001-0noitalugeRdaoL PYT XAM 1.0 5.0 %
noitalugeReniL CDVxaM-niM=niV PYT XAM 50.0 2.0 %
)4(ytilibatSmre
TtrohSPYT20.0%
ytilibatSmreTgnoLPYT2.0srHk/%
)5(esnopseRtneisnarTPYT030404sµ
)6(esnopseRcimanyDPYT031052571kaepVm
)7(noit
cejeRelppiRtupnI PYT06Bd
wbzHM02-0,esioN PYT XAM 0205 P-PVm
tneiciffeoCerutarepmeT PYT XAM 05 051 C°/mpp
)8(pmalCeg
atlovrevOPYT8.65181CDV
otnoitcetorPtiucriCtrohS stuptuOllarofnommoC daolrevOlamrehTdnatinmiLtnerruCmuminiMsru
oH8,suounitnoC