Technical Data AT44 Low Tack Protection Tape Issue 06 February 2000 General description A thin PVC film, coated with a low tack UV resistant adhesive. Flame retardant. Easy unwind. Flexible. Conformable to awkward shapes. Water resistant. Good abrasion resistance. UV resistant. Non-corrosive adhesive. Low tack. Clean peel. Technical Details Typical values 0.13mm Breaking Load 23 N/cm Elongation 150% Adhesion Steel 0.30 N/cm Service Temp 0C to +60C Application Temp 0C to +40C NOTE Except where indicated otherwise, the above figures are average values and should not be regarded as MAXIMUM or MINIMUM values for specification purposes. The Company reserves the right to improve products and any change in specification will result in a re-issue of the relevant `Technical Data Sheet'. Customers should satisfy themselves that the tape is suitable for their requirements whether after such modifications or otherwise. Please check that you have the latest issue of the `Technical Data Sheet'. All slitting and length tolerances are to British Standards. Before use the customer is advised to consult the Health & Safety Data Sheet produced by the company for this product, which is available on request. STORAGE Tapes stored below the minimum recommended temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place. RE ED Thickness GI S TE R BS EN ISO 9002 Q05206 Advance Tapes International Limited, PO Box 122, Abbey Meadows, Leicester, LE4 5RA. Tel: 0116 251 0191. Fax: 0116 265 2046. www.advancetapes.com AFERA Association des Fabricants Europeens de Rubans Auto-Adhesifs.