Workmanship Specification 101-28041 14 Jan 2009 Rev A DCR-D20090114135957-820808 Ultrasonic Welding, LC & SC Adapters 1. SCOPE This specification covers the acceptable and not acceptable conditions for the Ultrasonic Welding operation of the LC & SC adapters. 2. INSPECTION CRITERIA Unless otherwise specified, figures are shown under Magnification. The welded adapters will be inspected without magnification. 8 2005 Tyco Electronics Corporation, Harrisburg, PA All International Rights Reserved * Trademark | Indicates change 1 of 13 LOC B 101-28041 ACCEPTABLE Tool Marks LC Secure Figure 1 Acceptable Tool Marks SC Figure 2 Rev A 2 of 13 101-28041 Acceptable Tool Marks LC, LC Cutout Figure 3 Not ACCEPTABLE Heavy Tool Marks and Flash LC Secure Figure 4 Rev A 3 of 13 101-28041 NOT ACCEPTABLE Heavy Tool Marks and Flash SC Figure 5 NOT ACCEPTABLE Heavy Tool Marks and Flash LC, LC Cutout Figure 6 Rev A 4 of 13 101-28041 ACCEPTABLE Flash Around the Weld Line LC Secure Figure 7 ACCEPTABLE Flash Around the Weld Line SC Figure 8 Rev A 5 of 13 101-28041 ACCEPTABLE Flash Around the Weld Line LC, LC Cutout Figure 9 Not ACCEPTABLE Heavy Flash Around the Weld Line LC Secure Figure 10 Rev A 6 of 13 101-28041 Not ACCEPTABLE Heavy Flash Around the Weld Line SC Figure 11 Not ACCEPTABLE Heavy Flash Around the Weld Line LC, LC Cutout Figure 12 Rev A 7 of 13 101-28041 ACCEPTABLE Weld at Break Test LC Secure Figure 13 ACCEPTABLE Weld at Break Test, SC Figure 14 Rev A 8 of 13 101-28041 ACCEPTABLE Weld at Break Test, LC, LC Cutout Figure 15 Not ACCEPTABLE Weld At Break Test Flash at Alignment Sleeve Cavity LC Secure Figure 16 Rev A 9 of 13 101-28041 Not ACCEPTABLE Weld At Break Test Flash at Alignment Sleeve Cavity LC, LC Cutout Figure 17 Not ACCEPTABLE Gap Between Housings LC Secure Figure 18 Rev A 10 of 13 101-28041 Not ACCEPTABLE Gap Between Housings SC Figure 19 Not ACCEPTABLE Gap Between Housings LC, LC Cutout Figure 20 Rev A 11 of 13 101-28041 Not ACCEPTABLE Housings Reversed Figure 21 Not ACCEPTABLE Weld Fractures LC Secure Figure 22 Rev A 12 of 13 101-28041 Not ACCEPTABLE Broken Stack Figure 23 Not ACCEPTABLE Broken Latch Figure 24 Rev A 13 of 13