3.2 x 5 mm TCVCXO TV105A Series Description: Features: * The TV105A Temperature Compensated Voltage Controllable Crystal Oscillator (TCVCXO) Series products provide a wide range of options in temperature stability, operating frequency range, and electronic frequency adjustment in a miniature 3.2 x 5 mm ceramic SMD package. * * * * * * Available in frequencies from 10 to 52 MHz with 13 MHz, 14.4 MHz, 20 MHz, and other frequencies as standards +/-5 to +/- 20 ppm pull range Clipped Sine or CMOS output Standard 3.2 x 5 mm ceramic SMD package Analog Frequency vs. Temperature compensation technique Excellent for GPS Applications RoHS-6 Lead-free compliant Frequency Range, Operating Temperature, and Frequency Stability: Frequency Range 10 to 52 MHz Operating Temperature -20 to +70 C -40 to +85 C 0 to +55 C -10 to +60 C -30 to +85 C Product Code C D E F G Frequency Stability +/- 0.5 ppm +/- 1.0 ppm +/- 1.5 ppm +/- 2.0 ppm +/- 2.5 ppm Product Code A B C D E ** Not all combinations of frequency stability over temperature available. Consult the factory for your specific requirements. Aging: (typical at 10 MHz after 30 days continuous operation) Frequency 10 MHz Aging +/- 1.0 ppm Product Code N/A Offset 1 Hz 10 Hz 100 Hz 1 KHz Phase Noise (Typ.) - 60 dBc/Hz - 85 dBc/Hz -115 dBc/Hz -135 dBc/Hz Product Code 10 KHz 100 KHz -148 dBc/Hz -150 dBc/Hz Timeframe 1st Year Phase Noise: Frequency 10.0 MHz www.bliley.com N/A 2545 West Grandview Blvd Erie, PA. 16506 Page 1 of 2 Tel (814) 838-3571 Rev 2.0 3.2 x 5 mm TCVCXO TV105A Series Supply Voltage (Vs): Power Supply (Vs) Product Code +3.3 Vdc +/-10% C +5.0 Vdc +/-10% D Current Consumption: Clipped Sine Wave Supply Current 2.5 mA Environmental: Storage Temperature -55 to +125 C Output Waveform: Product Code Output Level Load Clipped Sine HCMOS Wave Output H N/A 0.8 V p-p min. 10% / 90% Vs 15pF 10K // 10 pF Pulling Range: Tuning None(TCXO) +/-5 ppm +/-8 ppm +/-10 ppm +/-12 ppm +/-15 ppm +/-20 ppm Range Product T A B C D E F (Pin 1 - Ground) Code **Note: Maximum pull available dependent upon required temperature stability Ordering Options: Operating Frequency Supply Temperature Stability Voltage C A C D B D E C F D G E TV105A C A C A Pulling Range T A B C D E F Output N/A H Leave Blank for Clipped Sine Operating Frequency xx.xxxx MHz xx.xxxx MHz xx.xxxx MHz xx.xxxx MHz xx.xxxx MHz xx.xxxx MHz xx.xxxx MHz 10.0000 MHz Product Selection Code (refer to the above example): This part is RoHs compliant, -20 to +70C, +/- 0.50pm, 3.3 volt clipped sine wave with +/- 5 ppm pull, 10MHz operating frequency. ** Not all combinations available in this product www.bliley.com 2545 West Grandview Blvd Erie, PA. 16506 Page 2 of 2 Tel (814) 838-3571 Rev 2.0