R Raychem Corporation 300 Constitution Drive Menlo Park, CA 94025 800-227-4856 FAX 800-227-4866 PRODUCT: AGR400 DOCUMENT: SCD 24441 PCN: 595043 REV LETTER: D REV DATE: JANUARY 10, 2000 PAGE NO.: 1 OF 2 PolySwitch(R) PTC Devices Resettable Fuse Specification Status: RELEASED Electrical Rating Voltage: 16V DC MAX INSULATING MATERIAL: Cured, Flame Retarded Epoxy Polymer LEAD MATERIAL: 20 AWG Tin/Lead Plated Copper (0.8 mm [0.032] nom. diameter) PART MARKING: Raychem Logo and Voltage 16 G4 Part Identification Lot Identification (c a n b e o n b a c k ) TABLE I. INSTALLATION ENVELOPE DIMENSIONS: mm: in*: A B MIN MAX MIN MAX -8.9 -14.1 -(0.35) -(0.56) *Rounded off approximation C MIN 4.3 (0.17) D MAX 5.8 (0.23) MIN 7.6 (0.30) E MAX --- MIN --- MAX 3.0 (0.12) F TYP 1.2 (0.05) G MIN --- MAX 3.05 (0.120) TABLE II. PERFORMANCE RATINGS: CURRENT RATINGS AMPS AT 25C HOLD HOLD TRIP AT AT R1 MAX RA MAX 4.0 3.0 7.6 Reference Documents: Precedence: TIME TO TRIP INITIAL RESISTANCE SECONDS AT 25C, 20 A MAX OHMS AT 25C MIN MAX 2.0 0.0186 0.0390 R1 MAX 1 HR. POST TRIP RESISTANCE STANDARD TRIP OHMS AT 25C RA MAX TRIPPED-STATE POWER DISSIPATION OHMS AT 25C WATTS AT 25C TYP 0.061 0.085 2.5 PS400, PS300 (Ref for R 1 MAX ) This specification takes precedence over documents referenced herein. R Raychem Corporation 300 Constitution Drive Menlo Park, CA 94025 800-227-4856 FAX 800-227-4866 Effectivity: CAUTION: PolySwitch(R) PTC Devices Resettable Fuse PRODUCT: AGR400 DOCUMENT: SCD 24441 PCN: 595043 REV LETTER: D REV DATE: JANUARY 10, 2000 PAGE NO.: 2 OF 2 Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. TABLE III. AUTOMOTIVE SPECIFIC STRESS TESTS AND TEST CONDITIONS: ELECTRICAL STRESS TESTS TEST CONDITIONS (see note 2) ESD Voltage Withstand (see note 1) Short Circuit Fault Current Durability 25kV Fault Current Durability 350 cycles, 16V/100A End-of-life Mode Verification 1750 cycles, 16V/100A Jump Start Endurance (see note 1) Load Dump Endurance (see note 1) 3 cycles, 26V, 1 minute duration 25 cycles, 16V, 200A 10 cycles, 86.5V Note 1: The PolySwitch devices are tested in series with a load resistance and the voltages specified in the test conditions are shared between the PolySwitch device and the load resistance as specified in PS400. Note 2: Please refer to Appendix A of PS400 for the detailed test procedures