Raychem Corporation
300 Constitution Drive
Menlo Park, CA 94025
800-227-4856
FAX 800-227-4866
R
PolySwitch®
PTC Devices
Resettable Fuse
PRODUCT: AGR400
DOCUMENT: SCD 24441
PCN: 595043
REV LETTER: D
REV DATE: JANUARY 10, 2000
PAGE NO.: 1 OF 2
Specification Status: RELEASED
Electrical Rating
Voltage: 16V
DC
MAX
INSULATING MATERIAL:
Cured, Flame Retarded Epoxy Polymer
LEAD MATERIAL:
20 AWG Tin/Lead Plated Copper
(0.8 mm [0.032] nom. diameter)
PART MARKING:
Raychem Logo
and Voltage
Lot Identification
(can be on back)
Part Identification
16
G4
TABLE I. INSTALLATION ENVELOPE DIMENSIONS:
A B C D EFG
MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX TYP MIN MAX
mm: -- 8.9 -- 14.1 4.3 5.8 7.6 -- -- 3.0 1.2 -- 3.05
in*: -- (0.35) -- (0.56) (0.17) (0.23) (0.30) -- -- (0.12) (0.05) -- (0.120)
*Rounded off approximation
TABLE II. PERFORMANCE RATINGS:
CURRENT RATINGS TIME TO
TRIP INITIAL
RESISTANCE R
1 MAX
1 HR. POST TRIP
RESISTANCE
STANDARD TRIP
R
A MAX
TRIPPED-STATE
POWER
DISSIPATION
AMPS
AT 25°C SECONDS
AT 25°C, 20 A OHMS
AT 25°C OHMS
AT 25°COHMS
AT 25°CWATTS AT
25°C
HOLD
AT
R
1 MAX
HOLD
AT
R
A MAX
TRIP MAX MIN MAX TYP
4.0 3.0 7.6 2.0 0.0186 0.0390 0.061 0.085 2.5
Reference Documents: PS400, PS300 (Ref for R1 MAX)
Precedence: This specification takes precedence over documents referenced herein.
Raychem Corporation
300 Constitution Drive
Menlo Park, CA 94025
800-227-4856
FAX 800-227-4866
R
PolySwitch®
PTC Devices
Resettable Fuse
PRODUCT: AGR400
DOCUMENT: SCD 24441
PCN: 595043
REV LETTER: D
REV DATE: JANUARY 10, 2000
PAGE NO.: 2 OF 2
Effectivity: Reference documents shall be the issue in effect on the date of invitation for bid.
CAUTION: Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame.
TABLE III. AUTOMOTIVE SPECIFIC STRESS TESTS AND TEST CONDITIONS:
ELECTRICAL STRESS TESTS TEST CONDITIONS (see note 2)
ESD Voltage Withstand
(see note 1) 25kV
Short Circuit Fault Current Durability 25 cycles, 16V, 200A
Fault Current Durability 350 cycles, 16V/100A
End-of-life Mode Verification 1750 cycles, 16V/100A
Jump Start Endurance
(see note 1) 3 cycles, 26V, 1 minute duration
Load Dump Endurance
(see note 1) 10 cycles, 86.5V
Note 1: The PolySwitch devices are tested in series with a load resistance and the voltages specified in the test conditions are
shared between the PolySwitch device and the load resistance as specified in PS400.
Note 2: Please refer to Appendix A of PS400 for the detailed test procedures
