MAGNETIC SENSOR MP1013 Series Hall-effect proximity sensor with convenient snap-fit mounting. Features Solid State Reliability Excellent output stability over operating temperature range Regulated power supply not required Meets IEC529 IP67 for dust and water protection Open Collector (NPN) output can be used with bipolar switch or cmos logic circuits with suitable pull up resistor Applications: Speed sensing Door interlock sensing MP101301 and MP101302 - unipolar switch - Output switches low (off) when the magnetic field at the sensor exceeds the operate point threshold. - Output switches high (on) when the magnetic field is reduced to below the release point threshold - Interfaces with AS101001 magnet MP101303 - bipolar latch - Output latches high(on) in the presence of a south pole. - Output unlatches (low or off) in the presence of a north pole Water flow sensing Specifications Recommended pull-up resistor values: Volts DC Ohms 5 9 12 15 24 1K 1.8K 2.4K 3K 3K Dimensions inches (mm) Open Collector Sinking Block Diagram Sensor Pocket Specifications subject to change without notice. Revised 072512