MAGNETIC SENSOR
MP1013 Series
Hall-effect proximity sensor with convenient snap-fit mounting.
Features
Solid State Reliability
Excellent output stability over
operating temperature range
Regulated power supply not
required
Meets IEC529 IP67 for dust and
water protection
Open Collector (NPN) output
can be used with bipolar switch
or cmos logic circuits with
suitable pull up resistor
MP101301 and MP101302 –
unipolar s witc h
- Output switches low (off) when the
magnetic fiel d at the sensor exceeds
the operate point threshold.
- Output switches high (on) when the
magnetic fiel d is reduced to below
the release point threshold
- Interfaces with AS101001 magnet
MP101303 – bipolar latch
- Output latches high(on) in the
presence of a south pole.
- Output unlatches (low or off) in the
presence of a north pole
Applications:
Speed sensing Door interlock sensing Water flow sensing
Specifications
Recommended pull-up resistor values:
Volts DC 5 9 12 15 24
Ohms 1K 1.8K 2.4K 3K 3K
Dimensions inches (mm) Open Collector Sinking Block Diagram
Sensor Pocket
Specifications subject to change without notice. Revised 072512
