Manual Supplement
© 2007-2011 Fluke Corporation. All rights reserved. Printed in the U.S.A. x
Manual Title: 718 Users Supplement Issue: 4
Print Date: July 1998 Issue Date: 9/11
Revision/Date: 4, 3/06 Page Count: 3
This supplement contains information necessary to ensure the accuracy of the
above manual. This manual is distributed as an electronic manual on the
following CD-ROM:
CD Title: 718
CD Rev. & Date: 3, 2/2006
CD PN: 1549626
718 Users Manual Supplement
9/11 1
Change #1, 41517
On page 26, following the Weight specification add:
Protection Class: Pollution Degree II
Change #2
On page 5, under Table 3, add the following:
Conforms to relative Australian standards
Change #3
On page 1, replace the fifth paragraph with the following:
Your Calibrator is supplied with a holster, two installed 9 V alkaline batteries, one set of TL75 test leads, one set of
AC70A alligator clips, a Product Overview Manual, and a CD-Rom.
Change #4, 59695
On page 1, under the Pressure Calibrator heading replace the first paragraph with:
The Calibrator makes 5-digit pressure readings in the following units: psi, inH2O at 4 C, inH2O at 20 C, kPa,
cmH2O at 4 C, cmH2O at 20 C, bar, mbar, kg/cm2, inHg, mmHg, and inH2O at 60 F.
Manual Supplement 718 30G/100G Users Manual
2 9/11
On page 2, add the following to Table 1:
inH2O at 60 F
On page 25, replace the Pressure Sensor Input Table with:
Pressure Sensor Input
Model Range Max Accuracy
[1]
6 month 1 year
718 1G
-1 to 1 psi 5 psi
0.050 % 0.050 %
-7 to 7 kPa 34.5 kPa
718
30G
-12 to 30 psi 60 psi
0.025 % 0.035 %
-83 to 207 kPa 413 kPa
718
100G
-12 to 100 psi 200 psi
0.025 % 0.035 %
-83 to 690 kPa 1.4 mPa
718
300G
-12 to 300 psi 375 psi
0.035 % 0.050 %
-83 to 2.1 mPa 2.6 mPa
[1] In an RF field of 1 V/m to 3 V/m between the frequencies of
1.4 GHz to 2.0 GHz, add 120 counts to specified accuracy.
718 Users Manual Supplement
9/11 3
Change #5, 59845
In the Specification section, add the following:
Specifications apply to the 718 Pressure Calibrators with firmware version 4.0 or greater. To verify the
firmware version, press and hold an d power on the Calibrator.
