KVR1333D3S8R9SK4/8G - KINGSTON TECHNOLOGY

KVR1333D3S8R9SK4/8G

8GB (2GB 256M x 72-Bit x 4 pcs.) PC3-10600

CL9 Registered w/Parity 240-Pin DIMM Kit

DESCRIPTION

ValueRAM's KVR1333D3S8R9SK4/8G is a kit of four 256M x

72-bit (2GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM),

registered w/parity, 1Rx8 ECC memory modules, based on nine

256M x 8-bit FBGA components per module. Total kit capacity

is 8GB. The SPD's are programmed to JEDEC standard latency

DDR3-1333 timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses

gold contact fingers. The electrical and mechanical specifica-

tions are as follows:

FEATURES

•JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

•VDDQ = 1.5V (1.425V ~ 1.575V)

•667MHz fCK for 1333Mb/sec/pin

•8 independent internal bank

•Programmable CAS Latency: 9, 8, 7, 6

•Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

•Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)

•8-bit pre-fetch

•Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write [either on the fly using A12 or

MRS]

•Bi-directional Differential Data Strobe

•Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

•On Die Termination using ODT pin

•On-DIMM thermal sensor (Grade B)

•Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

•Asynchronous Reset

•PCB : Height 1.180” (30.00mm), double sided component

*Power will vary depending on the SDRAM and

Document No. VALUERAM1085-001.A00 04/02/12 Page 1

Memory Module Speciﬁ cations

SPECIFICATIONS

CL(IDD) 9 cycles

Row Cycle Time (tRCmin) 49.5ns (min.)

Refresh to Active/Refresh 160ns (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin) 36ns (min.)

Power (Operating) 1.545 W* (per module)

UL Rating 94 V - 0

Operating Temperature 0o C to 85o C

Storage Temperature -55o C to +100o C

Continued >>