NSVS934 Apr. 2013 NewJRC SAW FILTER NSVS934 Application 350MHz WLAN IF Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig.1. Table 1. Electrical Specifications Item Spec. Typ. Input and Output Impedance 50 Nominal Center Frequency (f0) 350.0MHz Insertion Loss 348.75351.25MHz 2.2dB max. 1.3dB Response Variation 348.75351.25MHz 1.3dB max. 0.3dB Input and Output VSWR 348.75351.25MHz 2.0 max. 1.5 Out of Band Rejection 250MHz 30dB min. 40dB (Relative to Through Level) 450MHz 30dB min. 37dB (Operating Temperature Range: -30~+85C) Maximum Rating: (Table 2) Table 2. Maximum Ratings Item Maximum Input Power Maximum DC Voltage Operating Temperature Range Storage Temperature Rating +20dBm 7.5V -30~+85C -40~+90C Mechanical Specifications: (Fig.2) Package is designed as small as 3.5x3.5x1.0[mm3] for SMD (Surface Mount Device) type. Notice: This part is electrostatic discharge sensitive and may be damaged by improper handling. http://www.njr.co.jp/products/device/index.html http://www.njr.com/products/device/index.html (Japanese) (English) NSVS934 Apr. 2013 IN 50 1 8 OUT 50 7 2 SAW 6 3 4 5 Fig.1 Measuring circuit (b) 3. 50.2 (a ) (c) 3 .50.2 221 OL ( 1) 1 .00 .2 (2) ( 0 .8) [ 5x] 4 3 5 Marking (1) Lot Number (a) Year (b) Month *Oct.--Nov.--Dec.--(c) Date 1-9--10-19--20-31--(2) Part Number Mark (0 .6) [8x ] ( 0. 9 5) 2 6 (1 .0 ) [2x ] ( 2.54 ) ( 1 .2 7) ( 0. 6) 1 7 8 Fig.2 Package dimensions (in mm) X Y Z 0 1 2 4.3 1.27 4.3 1.27 0.8 [6x] 1.3 [6x] Via - Hole( 0.3) 0.8 Fig.3 Desirable land area (in mm) Pin no. 1 2 3 4 5 6 7 8 Connection GND IN/OUT GND GND GND OUT/IN GND GND NSVS934 Apr. 2013 Notice 1. Use this component within operating temperature range. It might not be satisfied with electrical specification without operating temperature range. When it is used less than -30C or more than +85C, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. 2. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350C max., the time of soldering: 10 seconds max., the power of soldering iron: 30W max.. 3. Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. 4. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. 5. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. 6. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. And do not transport this component with bare hand. Note 1. This specification specifies the quality of this component as a single unit. Make sure that this component is evaluated and confirmed against this specification when it is mounted to your products. 2. The information contained herein may be changed without prior notice. It is therefore advisable to contact New Japan Radio Company before proceeding with the design of equipment incorporating this product. 3. The products are designed to be used with ordinary electronic equipment (data and communications equipment, office equipment, audio-video equipment, measuring instruments, etc). New Japan Radio Company does not assume any liability for the case using the products with the application required high reliability or safety extremely (such as space equipment, sea-bottom equipment, medical equipment etc). When intending to use any our product please contact our sales representatives in advance. NSVS934 Apr. 2013 IN 50 O 10 *27nH 11 SAW 39pF 12 Fig.1 Measuring circuit 10 (1) 6.50.20 0 *murata LQW18A series Insertion Loss [dB] Insertion Loss [dB] 33pF FREQUENCY CHARACTERISTICS S21 0 OUT 50 O *27nH 2 13.300.20 20 (a) (b) (1.260.13) 4 (C) (2) 30 6 40 50 J4Y1 VS971 8 10 CH1 : center 350 span 200 CH2 : center 350 span 50 S11 (R0.3) [4x] S22 (3) Marking (1) Manufacture's Mark (2) Lot Number (a) Year 2.0 max. (b) Month *Oct.--- X Nov.--- Y Dec.--- Z (2.54) (2.54) 11 S22 1-9 --- 0 10-19 --- 1 9 7 5 3 20-31 --- 2 7 (3) Part Number Mark 5 3 (2.540.15) 1 325 375 (1.4) 1 325 [12x] Frequency [MHz] Frequency [MHz] InsertionLoss [dB] (2.540.15) 10 12 (0.8) S21 0 1 2 3 4 5 20 30 Pin No. Connection 11 10 9 8 7 6 40 [12 x] VSWR 9 VSWR (0.76) S11 11 (c) Date 1 375 GND(PKG) 2 GND(PKG) 3 GND(PKG) 4 GND(PKG) 5 GND(signal) 7 GND(PKG) 8 GND(PKG) 9 GND(PKG) 10 GND(PKG) 11 (R0.3) 50 0 [12x] [MHz] mm) Fig.2 PackageFrequency dimensions(in Japan Radio Co.,Ltd. OUT/IN 6 12 1500 IN/OUT GND(signal)