BTM7740G
Data Sheet 10 Rev. 1.0, 2007-05-21
5 Electrical Characteristics
5.1 Absolute Maximum Ratings
Note: Stresses above the ones listed here may cause permanent damage to the device. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
Note: Integrated protection functions are designed to prevent IC destruction under fault conditions described in the
data sheet. Fault conditions are considered as “outside” normal operating range. Protection functions are
not designed for continuous repetitive operation.
Absolute Maximum Ratings1)
– 40 °C < Tj < 150 °C
1) Not subject to production test; specified by design
Pos. Parameter Symbol Limit Values Unit Remarks
min. max.
High-Side-Switches (Pins DHVS, IH1,2 and SH1,2)
5.1.1 Supply voltage VS– 0.3 42 V –
5.1.2 Supply voltage for full short circuit
protection
VS(SCP) –28V
5.1.3 HS-drain current2)
2) Single pulse
IS– 7 3)
3) Internally limited
ATA = 25°C; tP < 100 ms
5.1.4 HS-input current IIH – 5 5 mA Pin IH1 and IH2
5.1.5 HS-input voltage VIH – 10 16 V Pin IH1 and IH2
Status Output ST
5.1.6 Status pull up voltage VST – 0.3 5.4 V
5.1.7 Status Output current IST – 5 5 mA Pin ST
5.1.8 Low-Side-Switches (Pins DL1,2, IL1,2 and SL1,2)
5.1.9 Drain-Source-Clamp voltage VDSL 42 – V VIL =0V; ID≤1mA
5.1.10 Supply voltage for short circuit protection VDSL(SCP) –30VVIL =5V
5.1.11 – 20 V VIL =10V
5.1.12 LS-drain current2) IDL – 7 3) ATA = 25°C; tP < 100 ms
5.1.13 LS-input voltage VIL – 0.3 10 V –
Temperatures
5.1.14 Junction temperature Tj– 40 150 °C–
5.1.15 Storage temperature Tstg – 55 150 °C–
ESD Protection4)
4) ESD susceptibility HBM according to EIA/JESD22-A114-B (1.5kΩ, 100pF)
5.1.16 Input LS-Switch VESD –2kV
5.1.17 Input HS-Switch VESD –1kV
5.1.18 Status HS-Switch VESD –2kV
5.1.19 Output LS and HS-Switch VESD – 8 kV all other pins connected
to Ground