Shop Learn Blog Forums Videos Adabox IO Sign In 0
Products
RASPBERRY PI / PI HATS & BONNETS & ADD-ONS / PLATES / RASPI
ROBOT BOARD V3 BY MONKMAKES
DESCRIPTION
The RaspiRobot Board v3 is an expansion board designed to turn your Raspberry Pi into a
motor controller! This board comes fully assembled and includes a switched-mode power
supply so you can supply your Raspberry Pi from a variety of battery packs.
The v3 fits right on top of your Pi's GPIO socket and allows for bi-directional control of both
motors with an L293D H-Bridge motor driver chip. It also allows for control of both motor's
speed independently and to use lower voltage motors than the voltage of your battery pack.
The board can also supply the Raspberry Pi with up to 2 amps of power using a switch mode
power supply, allowing you to run a fully-loaded Pi and the robot from 6xAA batteries (not
included!)
Good for use with any two 5-12V DC Motors or Steppers!
V3 Features:
Dual bi-directional motor control using TB6612FNG dual H-bridge
Dual open drain 2A MOSFET outputs
RasPi Robot Board v3
by MonkMakes
PRODUCT ID: 1940
DISCONTINUED
DESCRIPTION
TECHNICAL DETAILS
Socket for HC-SRo4 Rangfinder
Socket for 5V i2c Interface
Provides 5V regulated power to Raspberry Pi (efficient SMPS)
2 x user controllable LEDs
2 x header pins for switches
Reverse polarity protection
Open Source Python Software library
Screw terminals for motor connections
Compatible with:
Raspberry Pi Model B+
Raspberry Pi Model A+
Raspberry Pi 2
For source code and support, check out the RasPi Robot Board v3 github page!
Note: As Tuesday, January 12th 2016, we are now selling the RaspiRobot v3! Here are the
main changes from the v2:
More efficient TB6612FNG motor driver
Higher power (2A) open collector outputs
Power to motors now supplied from battery side instead of regulated side
Updated library allow you to specify battery voltage (9V to 12V) and motor voltage (1V up
to the battery supply voltage)
TECHNICAL DETAILS
An error occurred.
Try watching this video on www.youtube.com, or enable JavaScript if it is disabled in your browser.
Dimensions:
51mm x 51mm / 2.0" x 2.0"
Thickness w/ Components: 24mm / 0.9"
Weight: 21.8g
Datasheet for TB6612FNG motor driver
For product support, replacement parts and warranty for MonkMakes products click here!
LEARN
MAY WE ALSO SUGGEST...
Battery Powered Raspberry Pi
Displays w/RaspiRobot Shield
Power a Raspberry Pi and
LED matrix display using a
RasPiRobot Board
Controlling Motors using the
Raspberry Pi and RasPiRobot
Board V2
Learn how to use the RRBV2
to control motors.
Using a 5V Stepper Motor
with the RasPiRobot Board
V2
Control a 5V stepper motor
with the RasPiRobot Board
using Python and the RRB2
library.
EXPAND TO SEE DISTRIBUTORS
DISTRIBUTORS
