Memory Module Specifications KVR16LN11K2/8 8GB (4GB 1Rx8 512M x 64-Bit x 2 pcs.) PC3L-12800 CL11 240-Pin DIMM Kit DESCRIPTION SPECIFICATIONS ValueRAM's KVR16LN11K2/8 is a kit of two 512M x 64-bit CL(IDD) 11 cycles (4GB) DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 1Rx8, Row Cycle Time (tRCmin) 48.125ns (min.) low voltage, memory modules, based on eight 512M x 8-bit Refresh to Active/Refresh Command Time (tRFCmin) 260ns (min.) FBGA components per module. Total kit capacity is 8GB. The SPDs are programmed to JEDEC standard latency DDR3-1600 Row Active Time (tRASmin) 35ns (min.) timing of 11-11-11 at 1.35V or 1.5V. Each 240-pin DIMM uses Maximum Operating Power @1.35V TBD W* gold contact fingers. The electrical and mechanical specifications are as follows: (per module) UL Rating 94 V - 0 Operating Temperature 0o C to 85o C Storage Temperature -55o C to +100o C FEATURES * JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply * VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) * 800MHz fCK for 1600Mb/sec/pin * 8 independent internal bank * Programmable CAS Latency: 11, 10, 9, 8, 7, 6 * Programmable Additive Latency: 0, CL - 2, or CL - 1 clock * 8-bit pre-fetch * Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] * Bi-directional Differential Data Strobe * Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm 1%) * On Die Termination using ODT pin * Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C * * Asynchronous Reset *Power will vary depending on the SDRAM. PCB Height: 0.740" (18.75mm) or 1.180" (30.00mm) Important Information: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here. Continued >> Document No. VALUERAM1443-001.B00 03/26/15 Page 1 MODULE DIMENSIONS: Document No. VALUERAM1443-001.B00 Page 2