YAGEO CORPORATION ALUMINUM ELECTROLYTIC CAPACITORS
RECOMMENDED APPLICA TIONS
Long Life 5000 Hours at 105ºC Assured with Full Rated Maximum Ripple Current Applied
Suitable for Electronic Ballast and Other Long Life Equipment
Special designs are available upon requests.
Miniature Size Aluminum
Electrolytic Capacitors
SG [ Electronic Ballast ]
105°C Single-Ended Lead Aluminum Electrolytic Capacitors
FEATURES
Life Time : 105ºC, 5000 Hours
Radial Lead Type with the Standard Case Sizes Ranging from ø10 x 19 to ø22 x 40
FREQUENCY CORRECTION F A CTOR FOR RIPPLE CURRENT
FREQUENCY (Hz) CORRECTION FACTOR
50.60 0.80
120 1.00
300 1.20
1K 1.40
10K ~ 100K 1.60
DESCRIPTION
For Detail Specifications, Please Refer to
Engineering Bulletin No. 2064
DIA GRAM OF DIMENSIONS
Dø F dø
4.0 1.5 0.45
5.0 2.0 0.5
6.0 2.5
8.0 3.5
10.0 5.0 0.6
12.0
13.0
16.0 7.5 0.8
18.0
22.0 10.0 0.8
Dimensions : mm
Rubber End Seal
Vinyl Sleeve
(P.V.C)
L 15Min. D±0.5
F±0.5
5Min.
L15Min.
0.4Max.
D±0.5
F±0.5
Rubber End Seal
Vinyl Sleeve
(P.V.C)
5Min.
Rubber Stand-off
L≤12 L + 1.5Max.
13≤L≤15 L
L≥16 L + 2.0Max.
+1.0
-0.5
33
SPECIFICATIONS
Operating Temp. Range 160 to 400VDC : -40 to +105ºC 450VDC : -25 to +105ºC
Working Voltage 160 to 450VDC
Rate Capacitance Range 3.3 to 330µF
Capacitance T olerance ±20% (120HZ / +25ºC)
DC Leakage Current I ≤ 0.06cv + 10 (µA) After 2 Minutes Application of Rated Working Voltage at +25ºC
D.F WV(V) 120HZ / +25ºC 160 200 250 350 400 450
D.F (%) 15 15 15 20 24 24
Characteristics at WV (V) 160 200 250 350 400 450
Low Temperature Z (-25ºC) / Z (+20ºC) 3 3 3 5 5 6
Z (-40ºC) / Z (+20ºC) 6 6 6 6 6
Endurance (Load Life) After 5000 hours application of DC voltage with specified ripple current (≤ rated DC working voltage) at +105ºC,
the capacitor shall meet the following limits.
Capacitance Change ± 20% of Initial Measured Value
Dissipation Factor ≤ 200% of Initial Specified Value
Leakage Current ≤ Initial Specified Value
Shelf Life 1000 Hours No Voltage Applied
Capacitance Change Within 20% of Initial Value
Dissipation Factor Not Exceed 200% of Initial Requirement
Leakage Current Not Exceed 200% of Initial Requirement
CASE SIZE OF STAND ARD PR ODUCTS Dø ≥ 6mm with Safety Vent at Can Bottom
CAP. (µF) WV (SV)
160 (200) 200 (250) 250 (300) 350 (400) 400 (450) 450 (500)
D x L IMPE- RIPPLE D x L IMPE- RIPPLE D x L IMPE- RIPPLE D x L IMPE- RIPPLE D x L IMPE- RIPPLE D x L IMPE- RIPPLE
DANCE CURRENT DANCE CURRENT DANCE CURRENT DANCE CURRENT DANCE CURRENT DANCE CURRENT
3.3 10x19 6.5 60
4.7 13x20 3.6 80
10.0 10x19 3.5 100 10x19 3.0 100 10x19 2.9 100 13x20 3.0 110
22.0 10x19 1.52 160 10x19 1.50 160 13x20 2.5 160 13x20 2.1 160 13x25 1.35 170 16x25 1.8 190
16x20 1.00 200 18x20 2.2 200
33.0 10x19 1.30 210 13x20 0.95 210 13x20 1.9 210 13x25 1.00 230 16x25 0.95 230 16x32 1.3 275
16x20 0.91 250 18x20 0.91 250 18x25 1.2 280
47.0 13x20 0.95 260 13x20 0.91 260 13x25 1.7 270 16x25 0.75 300 16x32 0.75 300 18x32 1.0 340
16x20 1.5 275 18x20 0.80 315 18x25 0.80 325
68.0 13x25 0.60 360 13x25 0.60 360 16x25 0.80 380 16x32 0.50 400 18x36 0.49 420 18x40 0.8 460
16x20 0.55 430 16x20 0.55 430 18x20 0.90 375 18x25 0.55 380
100.0 16x25 0.30 475 16x25 0.30 475 16x32 0.65 520 18x32 0.40 530 18x40 0.34 545 22x40 0.6 580
18x20 0.31 465 18x20 0.31 465 18x25 0.65 500
150.0 16x32 0.22 650 18x25 0.27 650 18x32 0.45 650 22x40 0.30 650
18x25 0.24 625
220.0 16x32 0.22 750 18x32 0.22 780 18x40 0.35 820
18x25 0.24 725
330.0 18x32 0.22 960
Note : øD x L : mm, Ripple Cur rent Spec : 120HZ / +105ºC (mA, rms), Impedance Spec : 100KHZ / +25ºC (Ω Max.)
TEMPERATURE CHARA CTERISTICS
Capacitance Change Ratio Dissipation Factor Change
LO AD LIFE
Capacitance Change Ratio Leakage Current Change
Dissipation Factor Change
80400-40
-30
-20
-10
0
10
20
30
40
120
220µF 200v
47µF 400v
Temperature in °C
∆C/C
(%)
Temperature in °C
D.F
(%)
12040 800-40
5
10
50
100
47µF 400v
220µF 200v
3000 500010005000
-20
-10
0
10
∆C/C
(%)
Time in Hours
47µF 400v
250µF 200v
3000 5000
10005000
10
0
20
30
40
Time in Hours
D.F
(%) 47µF 400v
220µF 200v
3000 500010005000
50
100
500
1000
Time in Hours
LC
(µA)
47µF 400v
220µF 200v
34
