STANDARD
MICROCIRCUIT DRAWING
SIZE
A
5962-88622
DLA LAND AND MARITIME
COLUMBUS, OHIO 43218-3990 REVISION LEVEL
D SHEET 3
DSCC FORM 2234
APR 97
1.4 Recommended operating conditions.
Supply voltage (VS) .................................................................................................... 4.5 V to 15 V
Ambient operating temperature range (TA) .................................................................. -55C to +125C 4/
2. APPLICABLE DOCUMENT S
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-385 35 - Integrated Circuits, Manufacturing, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883 - Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard Electronic Comp onent Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents ar e available online at http://quicksearch.dla.mil or from the Standardization Document Order
Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094).
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text
of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3. REQUIREMENTS
3.1 Item requirements. The individual item requirements shall be in accordance with MIL-PRF-38535, appendix A for non-
JAN class level B devices and as specified h erein. Product built to this drawing that is produced by a Qualified Manufacturer
Listing (QML) certified and qualified man ufacturer or a manufacturer who has been granted transitional certification to
MIL-PRF-38535 may be processed as QML product in accordance with the manufacturers approved program plan and
qualifying activity approval in accordance with MIL-PRF-38535. This QML flow as documented in the Quality Management
(QM) plan may make modifications to the requirements herein. These modifications shall not affect form, fit, or function of the
device. These modifications shall not affect the PIN as described herein. A "Q" or "QML" certification mark in accordance with
MIL-PRF-38535 is required to identify when the QML flow option is used.
3.2 Design, construction, and physica l dimensions. The design, construction, and ph ysical dimensions shall be as specified
in MIL-PRF-38535, appendix A and herein.
3.2.1 Case outlines. The case outlines shall be in accordance with 1.2.2 herein and figure 1.
3.2.2 Terminal connections. The terminal conn ections shall be as specified on figure 2.
3.3 Electrical performance characteristics. Unless otherwise specified herein, the el ectrical performance characteristics are
as specified in table I and shall app ly over the full ambient operating temperature range.
_____
4/ The maximum operating junction temperature is +150C. At elevated temperatures, the device must be derated based
on package thermal resistanc e.