www.advantech.com/products
Online Download
Features
PCM-9562 Intel® Atom™ N450/D510 EBX SBC with 3
LAN, 6 COM, 3 SATA, 8 USB 2.0, 2 Watch Dog
Embedded Intel® Atom™ processor N450 Single Core/D510 Dual Core 1.66
GHz + ICH8M
Supports up to 3 Intel GbE Ethernet, 2 Watch Dog timer support
Design complies with UL60601 on LAN3 and COM6 port isolation
Power off protection and Software I2C API support
Supports embedded software APIs and Utilities
Specifications
Processor System
CPU Intel Atom N450/D510 1.66 GHz
Front Side Bus 667MHz
Frequency Atom N450/D510 1.66 GHz
L2 Cache 512 KB/1 MB
System Chipset N450/D510 + ICH8M
BIOS AMI 16 Mbit
Memory
Technology DDR2 667
Max. Capacity 2 GB
Socket 1 x 200-pin SODIMM
Display
Chipset N450/D510
VRAM Optimized Shared Memory Architecture up to 224 MB
Graphics Engine Embedded Gen3.5+ GFX Core, HW MPEG2 decoder
LVDS Single channel 18-bit LVDS up to WXGA 1366 x 768
VGA N450: Up to SXGA 1400 x 1050 @ 60 Hz (SXGA)
D510: up to 2048 x 1536 (QXGA)
Dual Display CRT+ LVDS
Ethernet
Interface 3 (RJ-45 connector through the cable and LAN3 is optional)
Controller LAN1 Intel 82567, LAN2 Intel 82583V, Optional LAN3 Intel 82583V (UL60601 Compliant) 10/100/1000 Mbps
Connector Box header
Audio Chipset ALC888 HD Codec, Speaker out, CD-input, Line-in, Line-out, Mic-in
Amplifier APA4863RI-TRG (Support )
WatchDog Timer
Output System reset
Interval Watchdog timer1 (IWT): monitor the system status before OS is ready (programmable 10ms, disable, 1s, 60s)
Watchdog timer2 (PWT): monitor the application status after OS is ready (programmable 1 - 255 sec/min)
Storage
CompactFlash Card Type I, Type II
SATA 3 SATA (Max. Data Transfer Rate 300 MB/s)
Floppy Share with LPT (Optional)
SPI Flash 16 Mbit
Internal I/O
Serial RS-232 x4 (optional COM6 is with isolation),
RS-232/422/485 x2 (Default RS-422/485, RS-232 by optional request)
Ethernet Giga LAN x 3 (RJ-45 connector through the cable and LAN3 is optional)
KB/Mouse 1
CRT 1
Reset Button 1
USB 8 x USB 2.0
Parallel (LPT) 1
FDD Share with LPT (Optional)
GPIO 16-bit GPIO
SMBUS 1
I2C 1
Expansion
PC/104-Plus slot 1
Mini PCI Express 1
PCI Slot 1
Power
Power Type AT / ATX (Both AT/ATX can support ACPI)
Power Supply Voltage ATX: 12V ±10%, 5VSB ±5% (5V stand-by power is only for auto power off function)
AT: 12V ±10% only
Power Consumption (Typical) PCM-9562N-S6A1E: 10.8W (893 mA @ 12V, 8 mA @ 5 VSB)
PCM-9562D-S6A1E: 13.6W (1130 mA @ 12V, 10 mA @ 5 VSB)
Power Consumption (Max, test in HCT) PCM-9562N-S6A1E: 13.9W (1159 mA @ 12V, 6 mA @ 5 VSB)
PCM-9562D-S6A1E: 16.9W (1404 mA @ 12V, 8 mA @ 5 VSB)
Environment Operating 0 ~ 60° C (32 ~ 140° F)
Non-Operating 95% @ 60° C Relative Humidity
Physical Characteristics Dimensions (L x W) 203 x 146 mm (8" x 5.75")
Weight 0.85 kg (1.87 lb) (with Heatsink)
MonitoringeSOS Embedded
Security ID
Flash Lock
Watchdog GPIOH/W Monitor BrightnessI2C SMBus Backlight On/Off
Software APIs:
Utilities:
NEW
BIOS Flash
5.25" Single Board Computers/ EBX /EPC CPU Boards
Board Diagram
Ordering Information
Model CPU CRT LVDS Giga
LAN1
Giga
LAN2
Giga LAN3
UL60601 HD Audio USB
2.0 SATAII RS-232 RS-422/485 PC/104-Plus Mini PCIe CF Thermal Operating
Temperature
PCM-9562N-S6A1E Atom N450 1 18-bit 1 1 Optional Yes 8 3 3 2 Yes 1 1 Passive 0 ~ 60° C
PCM-9562D-S6A1E Atom D510 1 18-bit 1 1 Optional Yes 8 3 3 2 Yes 1 1 Active 0 ~ 60° C
PCM-9562NZ2-S6A1E Atom N450 1 18-bit 1 1 Optional Yes 8 3 3 2 Yes 1 1 Passive -40 ~ 85° C
* For PCM-9562 with 3 LAN and 6 COM sku, pls contact with field sales rep. Minimum Order quantity is required.
(PCM-9562 has 3 LAN and 6 COM sku with LAN3 and COM6 designed in for UL60601.)
* Wide temperature will use 1960002379 (50 x 50 x 30 mm) heatsink instead of 1960020569S000 (50 x 50 x 10mm)
PCM-9562
Optional Accessories
Part No. Description
PCM-10586-9562E Wiring kit for PCM-9562
1703100260 USB cable
CF-HDD-ADP CompactFlash 50-pin to IDE 44-pin adapter
170304015K AT cable 4P x 2/4200-H-4P 15 cm
Embedded OS
Part No. Description
OS
Win XPE 2070009030: XPE WES2009 Luna Pier V4.0 ENG
2070009031: XPE WES2009 Luna Pier V4.0 MUI24
SUSI 205E956000: SUSI 3.0 SW API for PCM-9562
B:20091009 XP
Packing List
Part No. Description Quantity
PCM-9562 SBC x1
9689000002 Mini Jumper Pack x1
2006956200 Startup Manual x1
2066956200 Utility CD x1
1700015741 ATX 5VSB cable x1
Intel N450/ D510
Processor
SATA
Connector x 3
DDR2 (2 GB)
SODIMM x 1
DMI x 4 (Up to 1GB/S)
667 MHz
18 bit LVDS
Connector
VGA
Connector
ICH8M
LVDS
ALC888
Audio
Connector
HD
Compact Flash
(Type-II)
IDE
PCA9555PW
16 Bits
GPIO
LPC Super I/O
(SCH3106)
SIR
(Share from COM2)
LPT Port / FDD
Connector
PS2 Keyboard/Mouse
COM2 Connecter
COM4, 5 Connector
(RS422/485 only)
LPC
GLCI
Intel 82583V
PCIe x 1
LAN1 Connecter
LAN2 Connecter
FAN1
PCIe x 1
Mini PCIe
BIOS
Intel 82583V
PCIe x 1 LAN3 Connector (optional)
FAN2
I2C
I2C Connector
COM1
Connector
COM6
Connector
(optional) Isolator
Isolator
Intel 82567V
Watchdog Timer
MAXIM6369 (for IWD)
COM3
Connector
PCI-104
PC/104
PCI Bus
ITE8888G ISA Bus
PCI Slot
USB 2.0 USB Port x 8
SMB Connector
SATA
SPI
SMB
SMB
Industrial Motherboards
Software APIs
Control Monitor
GPIO
General Purpose Input/Output is a flexible parallel interface
that allows a variety of custom connections. It allows users
to monitor the level of signal input or set the output status to
switch on/off a device. Our API also provides Programmable
GPIO, which allows developers to dynamically set the GPIO
input or output status. Watchdog
A watchdog timer (WDT) is a device that performs a specific
operation after a certain period of time if something goes wrong
and the system does not recover on its own.
A watchdog timer can be programmed to perform a warm boot
(restarting the system) after a certain number of seconds.
SMBus
SMBus is the System Management Bus defined by Intel®
Corporation in 1995. It is used in personal computers and
servers for low-speed system management communications.
The SMBus API allows a developer to interface a embedded
system environment and transfer serial messages using the
SMBus protocols, allowing multiple simultaneous device
control.
Hardware
Monitor
The Hardware Monitor (HWM) API is a system health
supervision API that inspects certain condition indexes, such as
fan speed, temperature and voltage.
I2C
I2C is a bi-directional two wire bus that was developed by
Philips for use in their televisions in the 1980s.
The I2C API allows a developer to interface with an embedded
system environment and transfer serial messages using the I2C
protocols, allowing multiple simultaneous device control. Hardware
Control
The Hardware Control API allows developers to set the PWM
(Pulse Width Modulation) value to adjust fan speed or other
devices; it can also be used to adjust the LCD brightness.
Display Power Saving
Brightness
Control
The Brightness Control API allows a developer to interface with
an embedded device to easily control brightness.
CPU Speed
Make use of Intel SpeedStep technology to reduce power power
consumption. The system will automatically adjust the CPU
Speed depending on system loading.
Backlight
The Backlight API allows a developer to control the backlight
(screen) on/off in an embedded device.
System
Throttling
Refers to a series of methods for reducing power consumption in
computers by lowering the clock frequency. These APIs allow the
user to lower the clock from 87.5% to 12.5%.
Software Utilities
BIOS Flash
The BIOS Flash utility allows customers to update the flash
ROM BIOS version, or use it to back up current BIOS by
copying it from the flash chip to a file on customers’ disk. The
BIOS Flash utility also provides a command line version and
API for fast implementation into customized applications. eSOS
The eSOS is a small OS stored in BIOS ROM. It will boot up in
case of a main OS crash. It will diagnose the hardware status,
and then send an e-mail to a designated administrator. The
eSOS also provides remote connection: Telnet server and FTP
server, allowing the administrator to rescue the system.
Embedded
Security ID
The embedded application is the most important property of
a system integrator. It contains valuable intellectual property,
design knowledge and innovation, but it is easily copied! The
Embedded Security ID utility provides reliable security functions
for customers to secure their application data within embedded
BIOS. Flash Lock
Flash Lock is a mechanism that binds the board and CF card
(SQFlash) together. The user can “Lock” SQFlash via the Flash
Lock function and “Unlock” it via BIOS while booting. A locked
SQFlash cannot be read by any card reader or boot from other
platforms without a BIOS with the “Unlock” feature.
Monitoring
The Monitoring utility allows the customer to monitor system
health, including voltage, CPU and system temperature and fan
speed. These items are important to a device; if critical errors
happen and are not solved immediately, permanent damage may
be caused.
Value-Added Software Services
Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying
drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms.
It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications.
