© 2009 Actel Corporation. All rights reserved.
FlashPro3 Device Programmer
Quickstart Card
This quickstart card applies to the FlashPro3 and FlashPro3X device programmers.
Kit Contents
Software Installation
If you are already using Actel's Libero® Integrated Design Environment (IDE), you have the
FlashPro software installed as part of Libero IDE. If you are using the FlashPro3 device
programmer for standalone programming or on a dedicated machine, download and install the latest
release of the FlashPro software from the Actel website. The installation will guide you through the
setup. Complete the software installation before connecting the FlashPro3 device programmer to
your PC.
Software releases: www.actel.com/download/program_debug/flashpro.
Hardware Installation
After installing the software successfully, connect one end of the USB cable to the FlashPro3 device
programmer and the other end to your PC USB port. The Found Hardware Wizard will open twice.
Use the wizard to install the driver automatically (recommended). If the Found Hardware Wizard
cannot find the drivers automatically, then ensure you have properly installed the FlashPro software
prior to installing the hardware. If the drivers still cannot be installed automatically, then install
them from a list or specific location (advanced).
If FlashPro was installed as part of the Libero IDE default installation, the drivers are located at
C:/Libero/Designer/Drivers/Manual. For a standalone FlashPro default installation, the drivers are
located at C:/Actel/FlashPro/Drivers/Manual. Actel recommends the automatic driver installation.
Quantity Description
1 FlashPro3 or FlashPro3X programmer standalone unit
1 USB A to mini-B USB cable
1 FlashPro3 10-pin ribbon cable
50200178-1/10.09
FlashPro3 Device Programmer Quickstart Card
Common Issues
If the On LED does not light up after FlashPro3 driver installation, the driver might not be installed
correctly and you must troubleshoot the installation. For more information, refer to the FlashPro
Software and Hardware Installation Guide and the “Known Issues and Workarounds” section of the
FlashPro software release notes: www.actel.com/download/program_debug/flashpro.
Documentation Resources
For further FlashPro software and FlashPro3 device programmer information, including user's
guide, installation guide, tutorial, and application notes, refer to the FlashPro software page:
www.actel.com/products/hardware/program_debug/flashpro.
FlashPro3X Technical Description
FlashPro3X is an ISP programmer you can use with your PC to program IGLOO®, ProASIC3®L,
ProASIC3, and Fusion devices. FlashPro3X enables changing the TCK mode to discrete, which
enables JTAG programming for non-compliant JTAG devices to be included in the JTAG chain
with the Actel device. FlashPro3X includes all FlashPro3 functionality.
Technical Support and Contacts
Technical support is available online at www.actel.com/support, by email at tech@actel.com, or by
phone:
Phone (NA): 800.262.1060
Phone (Int'l): +1 650.318.4460
Actel Sales offices, including Representatives and Distributors, are located worldwide. To find your
local representative go to: www.actel.com/company/contact.